Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Length adjustment of the footrests
Loosen the star screw on the
underside of the footrest (pho-
to 3) and adjust the length
as desired by pushing up or
down. Retighten the screw!
Adjusting the leg supports
To take the leg supports off, first raise the foot plates.
Press the locking lever and rotate the leg support to the
side (photo 4+5). Pull the leg supports up and out. To
mount them, perform the operation in the reverse order.
Ensure that the leg supports are correctly locked.
4
Raising the leg supports
To raise the leg supports, simply pull the leg support up-
wards into the desired position. The leg support locks by
itself in the adjusted position (photo 6).
Lowering the leg supports
To lower the leg support again, pull the lever and swing
the leg supports down (photo 7).
6
Drive Medical GmbH & Co. KG | As per: 02.07.2020 | Errors and alterations excepted
5
7
Adjusting seat height (rear wheel mount)
The height of the seat at the
rear can be adjusted in 2
heights. Remove the screw
of the wheel axle and remove
the axle. Mount the wheel at
the desired height and screw
the screw back in. Ensure that
the wheel axle is properly
tightened (photo 8)!
Adjusting seat height (front wheel mount)
The height of the seat can be
adjusted in increments and is
correspondingly adjusted in
the desired inclination of the
seat surface. To adjust, un-
screw the wheel axle screw
and pull it out. Now move the
wheel in the desired position
and reinsert the wheel axle
screw and tighten it (photo 9).
Ensure that the wheel axle is properly tightened!
Swiveling the armrests backwards
To swivel the armrest backwards, engage the release le-
ver at the front of the armrest and hold it down (photo 10)
while simultaneously pulling the armrest up until the arm-
rest is free. Now it can be swiveled backwards (photo 11).
10
EN
11
15
Instructions for use VIPER
Werbung
Kapitel
Inhaltsverzeichnis
