Troubleshooting - Greencut GD750X Serie Betriebsanleitung

TROUBLESHOOTING

The table includes some of the most common problems, their causes and solutions. If the machine does not start:
THE
THE SPARK
COMPRESSION
OF THE CYLINDER
PLUG IS OK
IS NORMAL
Yes Yes
Yes No
Lack of
Yes
compression
The engine
doesn´t turn
If the engine does not work properly, please find below some of the possible problems, possible causes and solutions:
PROBLEM
The machine chimes
Engine overheating
Engine does not work
properly
Engine stops or does
not idle
NOTE: In the event of not being able to resolve the problem, get in touch with an Official Technical
Service.
POSSIBLE CAUSE
• There is no fuel in the tank.
• The fuel filter is dirty.
• There is water in the fuel.
• The fuel you are using is not correct,
• The carburettor is dirty.
• The switch is on the off position.
• Spark plug dirty.
• Spark plug pipe is not properly connected.
• Loose spark plug.
• Worn pistons.
• Scratched cylinder.
• Choked engine.
POSSIBLE CAUSE
• Worn segments.
• Piston seizure.
• Loose crankshaft.
• Loose clutch.
• Operator is overworking the
unit.
• Clogged/dirty exhaust.
• Improper fuel.
• Carburador sucio.
• Filtro de aire sucio.
• Filtro de combustible sucio.
• Carburador mal regulado.
SOLUTION
• Refuel.
• Clean the filter.
• Replace it.
• Change the fuel for one with the
correct octane.
• Take your machine to an authorised
service centre.
• Switch to the "I" position.
• Clean the spark plug.
• Connect it.
• Tighten.
• Take your machine to an authorised
service centre.
• Take your machine to an authorised
service centre.
SOLUTION
• Take your machine to an authorised service centre.
• Take your machine to an authorised service centre.
• Take your machine to an authorised service centre.
• Take your machine to an authorised service centre.
• Pause every 10 minutes or allow the engine to
cool down.
• Take your machine to an authorised service centre.
• Replace fuel as appropriate.
• Take your machine to an authorised service centre.
• Clean the filter.
• Clean the filter.
• Take your machine to an authorised service centre.
67
EN