Troubleshooting - Greencut GTC130X Betriebsanleitung

52
FUEL FILTER
The fuel tank is equipped with a filter. It is located at the end of the fuel intake pipe and can be removed with the
help of a hook wire.
Check the fuel filter regularly. Do not allow dirt to get into the fuel tank to prevent the filter from getting dirty. A dirty
filter will make it more difficult to start the engine and will cause malfunctions or stop the engine.
Check the fuel. If you see dirt, replace it. If the inside of the fuel tank is dirty you can clean it with gasoline.
CHECKING THE SPARK PLUG
The most common problems when starting a machine are caused by a dirty or damaged spark plug. Clean the spark
plug and check it regularly. Check that the distance between electrodes is correct (0.6 - 0.7 mm).

TROUBLESHOOTING

The table includes some of the most common problems, their causes and remedies.
SYMPTOM
The machine bells
Engine overheats
The engine's not
going well.
The engine dies off
or does not hold up
to idle speed
NOTE: If you are unable to resolve the problem, please contact the Official Technical Service.
PROBABLE CAUSE
Worn segments
Used Piston
Crankshaft clearance
Clutch clearance
Uninterrupted overuse
Dirty exhaust pipe
Fuel is not suitable
Dirty carburetor
Dirty air filter
Dirty fuel filter
Poorly regulated carburetor
CORRECTIVE ACTION
Send your machine to Technical Service
Send your machine to Technical Service
Send your machine to Technical Service
Send your machine to Technical Service
Pause every 10 minutes of work and let the
engine cool down.
Send your machine to Technical Service
Replace the fuel
Send your machine to Technical Service
Cleaning the filter
Cleaning the filter
Send your machine to Technical Service