Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
INSTALLATION
STEP 1 – PREPARATION FOR MOUNTING THE FAUCET
1
shut off the water supply.
Remove the hexagonal nut, disk and
2
washer. Do not remove the O-ring
from the base of the faucet.
STEP 2 – INSTALLING THE FAUCET
Place the faucet with O-ring into the
hole in deck or lavatory. make sure
1
the O-ring is located between the
deck or lavatory and the bottom of the
faucet.
slide the washer, disk and hexagonal
2
nut over the flexible hose and secure
the faucet into place.
16
INSTALLATION
NOTE: Flow direction is denoted by the arrow on the solenoid housing.
1
2
3
O-RING
4
waSHER
dISC
NUT
5
1
2
O-RING
3
O-RING
waSHER
dISC
NUT
4
STEP 3 – CONNECTING THE wATER SUPPLY
Connect the Nipple and FILTER on the inlet
side of the solenoid.
Connect the quick connector on the outlet
side of the solenoid.
Connect the dual power box to the water
supply lines.
Connect the black flexible tube to the quick
connector on the top of the dual power box.
For battery versions: Place battery into the
Dual Power input box.
STEP 4– CONNECTING THE POwER SOURCE
Turn on the central water supply. Check for leaks.
Remove the protective sticker from the sensor.
Connect the power source.
Once the power source is connected,
wait 15 seconds to allow the system
to set the ideal sensor range. A LED
will flash continously to indicate this
adjustment period. The solenoid valve
will open for 1 second to indicate that
the ideal sensor range was set.
If the automatically adjusted sensor range is not satisfactory to your purposes,
please refer to the section entitled "settings adjustment".
15
sECONDs
17
Werbung
Inhaltsverzeichnis
