Preparation And Operation; Programme Selection - Beem SB-012 Gebrauchsanleitung

19

Preparation and Operation

Programme Selection

The On / Off button (4) can be used to switch between the different programmes. The device has
three programmes. The LED ring (5) indicates the selected programme by the colour.
Programme Control lamp
1
2
3
The degree to which the milk is heated is dependent on the temperature of the milk that
is used. For the best possible result, we recommend using cold milk from the fridge for
frothing.
To switch between the different programmes, press the On / Off button several times.
Markings in the Milk Jug
The milk jug (6) contains two different markings (PICTURE B):
MAX
Maximum fi ll level for heating without frothing (approx. 500 ml)
MAX
Maximum fi ll level for frothing (approx. 260 ml)
Preparation
PLEASE NOTE!
• Do not fi ll the milk jug if it is positioned in the base station! Remove the milk jug from the
base station to fi ll it.
• Never use the milk jug without milk!
• Never use the milk jug without the lid. Hot milk could spray out during frothing and
heating.
When the device is fi rst used, production-related additives (e.g. grease) may cause a small
amount of smoke and / or an odour to be produced. This is normal and not a device defect.
Insert
Stirring insert
Red
Frothing spiral
White Stirring insert
Stirring insert
Blue
Frothing spiral
Intended use
Heating milk
Preparing warm milk froth
Making warm cocoa /
hot chocolate
Making cold cocoa
Preparing cold milk froth
EN