Troubleshooting - EINHELL PS 13 Niro Betriebsanleitung

Anleitung PS 13 Niro_SPK7

12. Troubleshooting

Fault Test
Smell of gas a) Check the seal on the bottle
b) Check all the gas supply parts
with leakage detection spray or
soap suds
Burner fails to ignite a) Is there still gas in the cylinder?
b) Is the cylinder valve open?
c) Is the ignition unit correctly
connected?
d) Does the spark jump over from
the ignition?
Flame flashback – in rare cases a) A blubbering noise or a small
the flames may flash back as far explosion is produced
as the burner pipes
06.06.2006 14:03 Uhr Seite 13
Remedy
a) Replace it if the seal is defective
b) Tighten loose connections
a) Have the cylinder refilled.
b) Open the valve
c) Fit the ignition correctly as
described
d) Check the cable for defects
a) Close the cylinder valve
immediately, wait for 1 minute and
then restart the device. If this
phenomenon occurs again, clean
the burner and pipe
GB
13