Resetting The Headset; Safety Instructions; Care Instructions - ACV 2 GO Luxury Bedienungsanleitung

Resetting the headset

In Power OFF, press the Power button for about 10 seconds. The headset switches to Power
ON after 2 seconds. After another 3 seconds the headset switches off again and the status
LED flashes red 4 times. After a further 5 seconds, existing couplings are deleted, the status
LED flashes red/blue twice.

Safety instructions

Note 1: Make sure that the charger is suitable for the headset.
Note 2: Use only the supplied charging cable to charge the headset. By using any other
charger, you may violate the warranty and care instructions for this device and cause
hazards.
Note 3: Do not attempt to force open the built-in battery. You could damage the headset.
Note 4: The fully charged headset loses battery power even when not in use. Charge the
headset every three months if possible.
Note 5: Do not use the headset in environments that are too cold or too hot, as the tempera-
ture may adversely affect the operation of the headset even when fully charged. (The
optimum operating temperature is between -20°C and 60°C.)
Note 6: Do not throw the headset into open flames or water for disposal.

Care instructions

Do not use abrasive cleaners to clean the headset.
Keep sharp objects away from the headset so that it is not scratched or damaged.
Do not expose the headset to high temperatures, moisture or dust.
CE certification and safety approval
We hereby declare that the device complies with the fundamental requirements set out in the
European Directive 2014/53/EU. The full EU declaration of conformity can be obtained from
the address given on the title.