ACV 2 GO Luxury Bedienungsanleitung Seite 7

EN
User Manual Bluetooth Headset
Bluetooth headset should be used with the compatible devices which support Bluetooth wire-
less technology.This allows you to make calls and enjoy the music streaming at any time freely.
Please read this user manual carefully before using the headset, and also read your device's
user manual regarding the Bluetooth function, and pay attention to those important safety and
maintenance information. Please keep the headset away from children.
Status LED Information Earphone
Pairing mode
The status LED of the right earpiece flashes alternately red and blue when the headset is in
pairing mode.
Standby mode after successful pairing
The status LED of the right earpiece flashes blue every five seconds when the headset is con-
nected and not in use.
Call mode
The status LED of the right earpiece flashes red once every five seconds when a call is being
made.
Charging mode Headset
The earphone status LED lights red while the headset is charging. When charging is complete,
it goes out.
Switch on
After switching on, the status LED flashes blue.
Switch off
After switching off via the power button, the status LED flashes red.
Charging mode Charging box
The charging status indicator on the charging box lights blue while the headset is charging.
When charging is complete, the status LED goes out.
Charging the headset
Remove the protective film from the contacts of the two earphones.
Place the headset in the charging box and close it.
The charging status indicator on the charging box lights blue while the headset is charging.
When charging is complete, the status LED goes out.
Please fully charge the headset battery before using the headset for the first time. The headset
is fully charged in approximately two hours.
Please charge the headset in time as described above to extend the battery life. (If the headset
has not been used for a long time or the battery is completely depleted, it will take a few
minutes for the indicator light to work.)
Charging the charging box
Connect the supplied type C-USB cable to the charging socket of the charging box and to a USB
charger or PC. While the charging box is charging, the status LED lights up blue. The charging
status is indicated by the blue dots.
Turning on the headset
Method 1: To turn the headset off (Power OFF) on (Power ON), press and hold the Power
button for 2 seconds until the blue light is displayed.
Method 2: The headset turns automatically on when it is removed from the charger.