Werbung
Verfügbare Sprachen
Verfügbare Sprachen
SCHARTEC
a trademark of bau-shop-24
GmbH Fritz-Müller-Strasse 119
73730 Esslingen
Germany
WEEE Reg. Nr.: DE90317979
BattG Reg. Nr.: 21008776
Safety Instructions
Please read this manual before installation and use.
•
•
To prevent accidental operation of door drive, not attempt to code in the remote control while the door drive is moving / in use.
•
The signal may be interfered with by other radio devices in the environment (e.g. babyphones or the like that have the same frequency).
Therefore, this product must not be used with high-risk devices (e.g. cranes, heavy machinery, etc.).
•
Keep remote controls out of reach of children.
•
The remote control should only be used when in visual sight of the door / gate.
Remote controls should only be used by persons who have been properly instructed in it's use.
•
•
Protect the remote and receiver from rain, snow, direct sunlight, as well as dust.
•
To change the battery, loosen the screws on the back of the remote
Technical Data
• Frequency: 433.92 MHz Rolling-Code
• Transmitting power: 10 dBm
• Battery: 3V CR2032
• Operating Temperature: -20°C - +60°C
• Channels: 1
• Article number: ST201010
• Model number: Schartec T3501
Programming
1. Coding in the remote: Press the "Learn button", the "LED 1" lights up red. Press button "1" twice in succession, the
"LED 1" flickers for a few seconds, then goes out again. This means that the remote has been taught in and works as
follows: Button 1 = controls channel 1, Button 2 = controls channel 2
2. Deleting stored remotes: Press and hold the "Learn button", the "LED 1" lights up red. While keeping the button
held, after approx. 8 seconds the "LED 1" goes out again, now release the "Learn button". The LED now lights up red
again briefly and then goes out again. The deletion process is now finished.
3. Code in a remote using a remote that has already been coded in: Press "Button 1" and "Button 2"
simultaneously on the remote that has already been coded in. Then briefly press "Button 2" of the coded in remote
once. Now press "Button 1" twice in succession on the new remote. The new remote has now been coded in.
Schartec hereby declares that the radio equipment type Schartec T3501 complies with Directive 2014/53/EU. The full text of the EU Declaration
As a dealer for the distribution of electronic, battery-operated devices, we are obliged by law to inform our customers about the following:
Electrical and electronic devices, as well as batteries, must not be disposed of as household or residual waste, but must be delivered in the
appropriate acceptance and collection points. The complete version of the battery law can be found here: http://www.gesetze-im-internet.de/battg/
Remote Control
Simplified EU Declaration of Conformity (CE)
of Conformity can be requested at the following Internet address: www.schartec.de
Schartec
T3501
index.html
Werbung
