Operation - Flat Cat Spin Benutzerhandbuch

ON/OFF-
LED-LIGHT
STANDBY BUTTON
Switch on the
trolley.
POTI-
CONTROLLER
Adjust to the desired
ERROR-LED-LIGHT
speed by turning
clockwise.
POTI-MODE
Press the P key -
P-LED flashes red
DISTANCE ASSISTANT
20 metres: Distance key 1x tap.
30 metres: Tap the distance key twice.
Trolley moves off gently.
Emergency brake: Press the P button
once.

OPERATION

Press the P key. Set the potentiometer to the desired speed by turning it clockwise.
Stop the Flat Cat: Press the P button again. Trolley stops. By pressing the P button again, the trolley
continues to move at the previously set speed.
BEHAVIOUR WITH EMPTY BATTERY
Weak battery (<22 V): On/Off LED flashes (short interruption). Switch off the trolley using the standby
button. Manual operation only possible.
Safety circuit: Prevents uncontrolled behaviour: The trolley switches off when the battery is empty and can
be out of the user's reach and roll away uncontrollably.
HANDLE POSITION TOO LOW (Position sensor)
Standstill (drive is switched off). Cause: e.g. handle not opened, caddy has fallen over. Note: Error and
On/Off LED flash alternate. If the handle or the caddy is in position again - normal operation possible.
SAFETY MEASURES IN CASE OF OVERLOAD
High temperature on one of the motors: On/Off LED flashes. Trolley switches off so that the temperature
drops again. After cooling down, normal operation is possible again.
CRITICAL SYSTEM ERROR (SERVCIE REQUIRED)
LED flashes quickly. Caddy is locked. Wheels are in freewheel mode, caddy can be moved manually. Restart
is possible and a further initialisation (calibration) can eliminate the error.
EN