Herunterladen Inhalt Inhalt Diese Seite drucken

Deep Discharge Protection - Flat Cat Spin Benutzerhandbuch

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

CLEANING
Do not use high-pressure cleaner to clean the Trolley and do not drive into water higher than the
lower edge of the wheel hubs. We advise to clean Trolley with a damp cloth and if necessary with a mild
cleaner.
FRAME & WHEELS
Do not put any heavy items on Trolley, especially not on wheels during transport (i.e. in the car).
ELECTRONICS
Never pull the (electric) trolley behind you while sitting in the golf cart. Not only for safety reasons, but also to protect
the electronics and electrical components (overvoltage could occur).
If the load is too high, the electronics will switch to half power under temperature control. An overload occurs, for
example, if the trolley is pulled strongly behind.
BATTERY & CHARGER
Note: Please use only suitable original accessories from the manufacturer for your Flat Cat. Battery and charger are
not compatible with other makes or brands.
Notes on charging batteries:
LED display: Red battery charging / Green standby, battery fully charged.
Safety timer: about 8 hours. The timer starts automatically when the battery is connected to the charger.
1. Connect the appropriate Flat Cat battery to the charger (never use batteries from other manufacturers).
2. Plug the power plug into an electrical outlet.
3. When charging is complete (LED is green), unplug the power cord from the wall outlet and disconnect the battery
from the charger.
The battery should be charged after each round of golf. When storing the trolley for a longer period of time during
winter, disconnect all connectors on the trolley, charger and battery. A permanent charging of the battery is not
necessary. Simply charge for 60 minutes every 8 weeks and then disconnect all connectors again. Before the next
use or in spring, a normal charge of the battery is sufficient.
:
ATTENTION
STORE THE BATTERY OUTSIDE THE CADDY
! (
)

DEEP DISCHARGE PROTECTION

CARE AND SAFETY INSTRUCTIONS:
Never open the battery, short-circuit it, expose it to wetness or throw it into a fire. Always ensure correct polarity (+/-). Always
avoid short circuits, e.g. with metal objects. ATTENTION: the battery can leak, explode or cause a fire if not handled properly. The
life of each battery is limited and can be reduced by many misuses. Therefore always observe the following additional
instructions:
1. Always avoid deep discharge.
2. Avoid high ambient temperature.
3. Always charge batteries only with a suitable charger.
4. Do not dispose of old batteries in the household waste, please always take them to the designated collection points.
The charger is intended for indoor use only and should not come into contact with liquids, dust, moisture, heat or direct sunlight. To avoid
overheating, the charger should not be covered during use. Keep the device away from strong vibrations and do not drop the device. Keep
all easily flammable materials away from the charger. Do not use the unit in a potentially explosive environment. This device is designed
to charge lithium-ion or lithium-polymer batteries. For safety reasons, this charger may only be used for lithium-ion or lithium-polymer
batteries with a nominal voltage of 25.2 volts or 25.9 volts. Do not attempt to charge batteries that are not expressly designed by the
manufacturer for the charging technology, output voltage and currents of the charger. Do not try to charge defective or damaged
batteries. The mains socket should be easily accessible. If an operating error occurs, immediately remove the plug from the socket.
Dangerous voltages are present in the charger, therefore the cover should not be removed. All service and maintenance work should be
carried out by authorised specialists or by the manufacturer's representative. The charger is double insulated (insulation class II).
Chargers with plastic housing should not come into contact with oil, grease, etc., as most plastic materials can be dissolved by chemicals
and solvents. The manufacturer accepts no liability or responsibility for damage caused by incorrect operation, failure to follow the
instructions for use, failure to follow the maintenance instructions, lack of maintenance or other improper handling by the customer or a
third party (e.g. operating errors, incorrect connection, wilful damage, etc.)
EXCLUSION OF LIABILITY:
The manufacturer and supplier accepts no liability for incorrect or improper use and the resulting consequences. Any repair or
modification of the device not carried out bythe original supplierwill invalidate the warranty. The device may only be used by persons who
have read and understood these instructions. The device specifications may change without prior notice. This product is not a toy. Keep it
out of reach of children.
WASTE DISPOSAL:
Please inform yourself about the local collection points for electronic equipment. Please observe the local regulations and do not dispose
of your old equipment with normal household waste. The charger may only be disposed of at collection points set up by disposal
companies. The correct disposal of your old device is a contribution to the environment.
EN

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Verwandte Produkte für Flat Cat Spin

Inhaltsverzeichnis