Retekess T-AC01 Benutzerhandbuch Seite 6

private land mobile and fixed services
as certified by an organization representative of the user of those services.Replacement of any transmitter
component (crystal, semiconductor, etc.) not authorized by the local government radio management depa-rtments
equipment authorization for this radio could violate the rules.
FCC Requirements:
• This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation •
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation.This equipment generates uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
CE Requirements:
• (Simple EU declaration of conformity) Henan Eshow Electronic Commerce Co.,Ltd declares that the radio
equipment type is in compliance with the essential requirements and other relevant provisions of RED
Directive 2014/53/EU and the ROHS Directive 2011/65/EU and the WEEE Directive 2012/19/EU;
the full text of the EU declaration of conformity is available at the following internet address:
www.retekess.com.
• Disposal
The crossed-out wheeled-bin symbol on your product, litera-ture, or packaging reminds you that in the European
Union, all electrical and electronic products, batteries, and accumu-lators (rechargeable batteries) must be taken
to designated collection locations at the end of their working life. Do not dispose of these products as unsorted
municipal waste. Dispose of them according to the laws in your area.
IC Requirements:
Licence-exempt radio apparatus This device contains licence-exempt transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the
following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference, including interference that may cause undesired operation of the
device. Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes :
(1) l'appareil ne doit pas produire de brouillage;
(2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible
d'en compromettre le fonctionnement.
RF Exposure Information
• DO NOT operate the radio without a proper antenna attached, as this may damage the radio and may also cause
you to exceed RF expos-ure limits. A proper antenna is the antenna supplied with this
radio by the manufacturer or an antenna specifically authorized by the manuf-acturer for use with this radio, and
the antenna gain shall not exceed the specified gain by the manufacturer declared.
• DO NOT transmit for more than 50% of total radio use time, more than 50% of the time can cause RF exposure
compliance requirements to be exceeded.
• During transmissions, your radio generates RF energy that can possibly cause interference with other devices or
systems. To avoid such interference, turn off the radio in areas where signs are posted to do so.
• The device complies with RF specifications when the device used at 5mm from your body. Third-party belt-clips,
holsters, and similar acc-essories used by this device should not contain any metallic compon-ents. Body-worn
accessories that do not meet these requirements may not comply with RF
exposure requirements and should be avoided.
• DO NOT operate the transmitter in areas that are sensitive to electromagnetic radiation such as hospitals, aircraft,
and blasting sites.
Avoid Choking Hazard
Small Parts. Not for children under 3 years.
5