Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Note: The buzzer sounds loudly means that the operation is successful.
9. Change password
Press
*
Enter the programming code #
NOTE: In programming mode you can continue this operation.
10. Change open delay time
Press *
Enter the programming code #
Note: The door delay of 0-255 seconds, default 3 seconds, up to 255 seconds.
11. System initialization
Press * programming code
Note: The buzzer will sound once the operation is successful initialization, it will clear all the settings.
Swipe delete card-swipe add card-swipe delete card can also initialize this machine.
12 . Setting management card (add card and delete card)
Press *
programming code
Note : the first swiping card is add card, the second swiping card is delete card.This function is to facilitate the
operation of adding and deleting user card, set to add and delete cards
After this operation, you can swipe add card or delete card to add or remove users' card.
13. Set common password to open the door
Press * programming code
Note : the password default is 7890, you can enter 0000 to delete the common password when you enter the 4
digits password.
14. Exit the programming mode
Press * to exit the programming mode, if there is no action in 10 seconds it will exit automatically.
15. Open and close the function of alarm
Swipe the delete card 3 times to close the function of alarm, swipe the add card 3 times to open the function of
alarm.
◆ Access Control jumper settings
A, J1 active and passive output settings, when 1 and 2 are connected, COM, NC, NO is switch signal output.
When the 2 and 3 are connected, COM and GND shorted for active signal output. (note: when connect the
automatic door, J1 1 and 2 connected, then COM and NO access to the automatic door trigger port)
B, J2 RESET Reset Settings, after short circuit J2, power up can be initially the programmed password (it will not
clear the user data).
◆
Setting to copy the data
TXD and RXD of the main access control connect RXD and TXD of the subordinate access control, the TXD and
RXD must be connected in braces, then enter the password to copy data, the indicator red green lamp will spark
at the same time, the beep sound means that you have copy the data successfully. To have the password to copy
the data, you could consult the seller. (The main access control is who has data, the subordinate access control
is who does not have the data)
◆ Change the access control mode
Access control mode: Connect GLED and GND then electrify, when the green lamp flick you should disconnect
GLED and GND, the beep means it is successful (the default mode is the access control mode )
The mode of reading (Wiggins 26 output): Connect DO and GND then electrify, when the grenn lamp flick you
should disconnect DO and GND, the beep means that it is successful.
The mode of reading (Wiggins 34 output): Connect D1 and GND then electrify, when the green lamp flick you
should disconnect D1 and GND, the beep means that it is successful.
◆ wiring diagram
1，Normal power supply wiring picture
6
4 digits user code
7
open seconds #
#
8 Enter the programming
#
9 swipe card
# 9 Enter 4 digits password #
4 new code
or swipe master card
2
#
#
Werbung
