Safety Instructions; Operating Determinations - Omnitronic RM-105 Bedienungsanleitung

2. SAFETY INSTRUCTIONS

This device has left our premises in absolutely perfect condition. In order to maintain this condition and to
ensure a safe operation, it is absolutely necessary for the user to follow the safety instructions and warning
notes written in this user manual.
Maintenance and service operations are only to be carried out by authorized dealers. Damage, caused by
manual modifications on this device is not subject to warranty. If the device is used for other purposes than
originally intended or if it is not correctly connected, the product may suffer damages and the guarantee
becomes void.
Protect the device against humidity and heat. The ambient temperature must always be between -5° C and
+45° C. The relative humidity must not exceed 50 % with an ambient temperature of 45° C.
Never put any liquids on the device or close to it. Should any liquid enter the device nevertheless, remove
batteries. Please let the device be checked by a qualified service technician before you operate it again. Any
damages caused by liquids having entered the device are not subject to warranty!
Operate the device only after having familiarized with its functions. Do not permit operation by persons not
qualified for operating the device. Most damages are the result of unprofessional operation!
For cleaning the unit only use a soft lint-free and moistened cloth. Make sure not to allow any water to enter
and never use any solvent cleansers.

3. OPERATING DETERMINATIONS

This device is a multifrequency receiving unit, which serves as a replacement part or as an extension for the
PA system W.A.M.S.-05. The receiving unit operates in the UHF range of 863.100 - 864.900 MHz. The
frequency range is divided into 16 channels, which can be selected as desired. The hand-held microphone
HM-105, the transmitter module ALT-105 and the pocket transmitter TM-105 can be used for a
wireless signal transmission to the receiving unit as they are tuned to the same frequencies. The receiver
module was designed for indoor use only. Never remove the serial barcode from the device as this would
make the guarantee void.
3.1 Approval
This wireless system was tested in accordance with the European standards EN 300422-2, EN 301489-09
and EN 60065. Consequently, this product adheres to the R&TTE-Directive of the European Union and does
not need an individual EC type examination of every member state. The approval number is
In all EU member countries, the operation of this wireless system is generally approved by the national
telecom regulatory authority. The system is license-free.
In some countries outside the EU, the operation of this wireless system needs to be approved by the national
telecoms regulatory authority. Please refer to your authority via links from the following Internet address:
http://ec.europa.eu/enterprise/rtte/weblinks.htm.
Downloaded from www.Manualslib.com
Important:
Damages caused by the disregard of this user manual are not subject to warranty. The dealer will
not accept liability for any resulting defects or problems.
manuals search engine
9/12
1856.
00031457.DOC, Version 1.1