Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Unscrew the plate next to the existing receiver module of the W.A.M.S.-05 system and insert the
O
receiver module RM-105 instead or replace a defective module with a new one.
Occupation of the 10 strip conductor contacts (from left to right) [1]:
Pin
Function
1
antenna B
2
ground
3
+12 V operating voltage, 185 mA
4
ground
5
audio output
*
All four ground connections must be interconnected for proper operation.
6. OPERATION
O
To switch on the receiver module, advance the On/Off/Volume control from the position "OFF". The LED
A/B lights red or green depending on the receiving antenna A or B currently active.
O
Prior to switching on the transmitter (HM-105, ALT-105 or TM-105), first set the receiver unit to a
free transmission channel:
Press the SET button. The channel indication on the display starts flashing.
O
The channel indication keeps flashing for approx. 10 seconds. Meanwhile, the channel can be selected
O
with buttons P and Q.
Confirm the channel selection with the SET button (within 10 seconds) otherwise the unit returns to the
O
channel previously adjusted.
If the LED RF lights up after channel selection when the transmitter is switched off, interfering signals of
other transmitters are received on this channel. In this case, adjust the receiver unit to a different
channel.
O
To indicate the frequency instead of the channel on the display keep one of the buttons P or Q pressed.
(Please refer to chapter 8.1 Channel configuration for a table listing which channel is assigned to which
frequency).
O
If the transmitter is switched on and set to the same channel as the receiver unit, the LED RF lights up to
indicate reception of a radio signal. The LED AF lights up if the transmitter transmits an audio signal of
sufficient level on the radio frequency adjusted.
O
Adjust the desired volume for the audio signal received with the Volume control.
Downloaded from
www.Manualslib.com
*
*
manuals search engine
Pin
Function
*
6
ground audio
7
not required
8
not required
*
9
ground
10
antenna A
11/12
00031457.DOC, Version 1.1
Werbung
Inhaltsverzeichnis
