Technical Information; Rating Plate - AEG HC652601EB Benutzerinformation

18 www.aeg.com
The worktop cutout
Distance
from the
wall
Depth
Width
Example:
Assembly
1. Calculate correct cutout dimensions.
2. Prepare cutout in the worktop.
3. One by one place the hobs on a soft
4. Attach the supplied seal stripe to the
5. Loosely screw the fixing plates into
6. Insert first hob into the worktop
7. Loosely screw in the fixing plates

9. TECHNICAL INFORMATION

9.1 Rating plate

Modell HC652601EB
Typ 55 TEP 01 AU
Induction 5.6 kW
Downloaded from www.Manualslib.com
minimum 50 mm
490 mm
sum of all widths of hobs that
you install minus 20 mm
+ -
580 mm 360 mm 20 mm
surface (for example on a blanket)
with the bottom side up.
lower edge of the hob along the
outer edge of the glass ceramic.
the correct holes in the protective
casing.
cutout. Than insert the connection
bar into the worktop cutout. Push it
half of its width under the hob.
from below to the worktop and to
the connection bar.
manuals search engine
8. Insert next hob into the worktop
cutout. Make sure that the front
edges of the hobs are on the same
level.
=
920 mm
9. Tighten the fixing plates / retaining
grip screws.
10. Use silicone to seal the gaps
between the hobs and between the
hobs and the worktop.
11. Put some soapy water on the
silicone.
12. Press the rubber shape with some
strength against the glass ceramic
and move it slowly along the space.
13. Do not touch the silicone until it
becomes hard, it can last about a
day.
14. Carefully remove the silicone that
came out with a shaving blade.
15. Clean the glass surface.
PNC 949 595 446 00
220 - 240 V 50 - 60 Hz
Made in Germany