Aimetis E3200 Serie Handbuch Seite 9

To perform initial setup:
1. Connect the
the back panel.
2. Connect the power adapter to the
The power button will light up green and the hard disk activity indicator will flash as it boots.
• If a DHCP server is available on the network, the
IP address automatically.
• If no DHCP server is available, the
address automatically using automatic private IP addressing. The
PSA
with a
3. Connect your computer to the network.
adapter.
Figure 8: Front panel of E3200 PSA with power button indicated
to the network with a twisted-pair cat.5 or cat.6 cable using
E3200 PSA
E3200 PSA
will be set to
169.254.x.y
of
subnet 255.255.0.0
Figure 7: Back panel of E3200 PSA with LAN1 indicated
7
and press the power button on the front panel.
E3200 PSA
will assign itself an IP
E3200 PSA
(where is the device's unique identifier)
x.y
.
Ensure DHCP is enabled on your networking
Connect the E3200 PSA to the Network
on
LAN1
will obtain an
E3200