Aimetis E3200 Serie Handbuch Seite 28

3. Using the small screws with the integrated spring washer and flat washer, fasten the wall
mounts to the
4. Flip the unit over so that the Aimetis logo is now visible. Note that bar with the slotted screw
holes will sit flush against a wall.
Positioning the E3200 PSA on a Wall
When the unit is vertically mounted, you must ensure that all ports are either at the bottom or at the top of
the unit. This depends on how you want to connect cables from the
work. Decide which ports you want to access from the front panel or the back panel of the unit.
You can position the screws holding the
•
"Using the Mounting Template to Position the Unit"
•
"Manually Positioning the Unit"
Using the Mounting Template to Position the Unit
1. Place the paper template provided in your package against the wall on which you want to
install the
E3200 PSA.
2. Using a drill bit a little smaller than the closed end of the plastic anchor (use the same size for
metal anchors), drill a hole through the center of each of the four holes marked on the tem-
plate. Drill only as deep as the anchor.
3. Hammer the anchor into the wall.
4. Using a hand Phillips screw driver or your power drill, install the screw loosely.
5. Slip the slotted holes
Manually Positioning the Unit
1. Position the
2. Using a drill bit a little smaller than the closed end of the plastic anchor (use the same size for
metal anchors), drill a hole through the center of your mark. Drill only as deep as the anchor.
3. Hammer the anchor into the wall.
4. Using a hand Phillips screw driver or your power drill, install the screw loosely.
5. Test the position of the
6. Check your pencil marks. If necessary, remark all the other holes, and install the other anchors
and screws.
Mounting the E3200 PSA
.
E3200 PSA
Figure 26: Aimetis logo on top of unit
E3200 PSA
of the E3200 PSA
on the wall, and using a pencil, mark the slotted hole placement.
E3200 PSA
E3200 PSA
E3200 PSA
two ways:
over the screws. Position and tighten the screws.
by slipping one of the slotted holes over the screw.
26
to your cameras and net-