Residual Risks - TCE NEOS Serie Kurzanleitung Zur Installation

TCE Group S.r.l.

Residual risks

In the development phase TCE Group S.r.l. carried out a deep risk analysis on the system in question.
From this analysis, risks that cannot be eliminated due to their nature emerged. These risks have therefore been examined
individually and in this manual the guidelines on how to avoid them have been emphasized. It is therefore important that any user
responsible for configuring, using and maintaining the NEOS Series, has previously read the manual.
NOTE
THE MANUFACTURER CANNOT BE HELD IN ANY CASE LIABLE FOR ACCIDENTS OR DAMAGES
RESULTING FROM UNINTENDED USE OF THE DEVICE, AS A RESULT OF USER NEGLIGENCE
In particular:
• It is absolutely forbidden to make any modifications to the NEOS Series. Any damage to people, animals or things
resulting from the use of the device improperly modified by an unauthorized operator relieves the manufacturer from
any responsibility.
• Keep this manual carefully, as it is necessary for a correct and safe use of the NEOS Series. Periodically check the status
of the label applied to the product and restore it if it is damaged. (in case contact the service center)
• If the external structure of one of the components of the NEOS Series has sharp corners or edges following an
accidental impact, such as to make it dangerous, or to doubt the degree of the IP protection, it is necessary to contact
the service center and follow their instructions.
• Use only products with compatible devices as indicated in this document.
Important:
- Do not wet the electrical connections of the device with water or other liquids.
- Proceed with caution during the installation phases to avoid damaging the device.
- The installation must be optimally performed by specialized personnel.
- The electrical connection to the existing system must be performed by qualified personnel in accordance with the laws
and regulations in force.
- The power supply line must have cables with an adequate section evaluated on the basis of the serial number label plate,
and in any case not less than 1.5mmq.
- Do not power at a voltage different from that indicated on the serial number label plate.
- The device must be separated from any heat source (such as lighting appliances and fireplaces) or other types of chargers
or any other object that may emit harmful substances.
- Make sure that the DC cables are complete with plug and always raised from the floor even when the device is NOT
operating
- Make sure the DC cables do not tangle causing damage to their own integrity.
OPERATIONS INVOLVING RISKS FOR THE OPERATOR:
During the configuration and commissioning operations, comply with the general accident prevention regulations.
In particular:
- if you work on electrical parts, make sure they are not live.
Already in the development phase, solutions have been adopted to ensure safe use of the device at all stages of use: transport,
assembly, adjustment, use and maintenance. However, not all possible risks for operators and the environment have been
eliminated, both for technological reasons (reliability of the devices) and for management (excessive difficulties in elimination),
consequently the residual risks present are reported.
Installation, use and maintenance manual – Serie NEOS
17