National Instruments SCXI Serie Schnellstartanleitung Seite 5

Step 4. Install the Modules
Caution Make sure the chassis is completely powered off. SCXI modules are not hot-swappable.
Adding or removing modules while the chassis is powered on can result in blown chassis fuses or
damage to the chassis and modules.
PXI/SCXI Combination Chassis
To install the PXI E Series or M Series DAQ communicating device in the right-most slot of the PXI
chassis, complete the following steps:
1. Touch any metal part of the chassis to discharge static electricity.
2. Place the module edges into the top and bottom PXI module guides, as shown in Figure 4.
3. Slide the module to the rear of the chassis. Make sure that the injector/ejector handle is pushed
down.
4. When you begin to feel resistance, pull up on the injector/ejector handle to inject the module into
the frame.
5. Secure the module to the chassis front panel mounting rail using the two screws.
1 PXI DAQ Module
SCXI Chassis
1. Touch any metal part of the chassis to discharge static electricity.
2. Insert the module into the SCXI slot.
3. Secure the module to the chassis front panel mounting rail using the two thumbscrews.
1 Thumbscrews
SCXI Quick Start Guide
1
2
2 Injector/Ejector Handle
Figure 4. Installing the PXI Module in a New Chassis
®
1
5
4
3
2
1
2
1
Figure 5. Installing the SCXI Module in a New Chassis
4
3
3 Injector/Ejector Rail
2 Module
ni.com