Lenz Digital plus BM1 Betriebsanleitung Seite 8

8
feature "constant braking distance" of
the decoder. This will ensure that all
trains will come to a complete standstill
within the braking distance so defined.
4.1 "On the right means on the
right..."
...was a slogan on a motorway sign at
the end of the 1980s. It was meant to
remind drivers to change back to the
right-hand lane after overtaking a lorry.
The same is true when using the ABC:
"on the right means on the right". It is
always the track that is on the right
depending on the direction of travel that
is separated when installing a braking
section.
Separate the right-hand track at the
beginning and at the end of the braking
section. Alternatively, you can use an
insulating track connector if there is a
track joint at the respective point.
Connect terminal "1" of the BM1 with
the right-hand track before the braking
section.
Connect terminal "2" of the BM1 with
the insulated braking section "A".
Use a switch parallel to the terminals 1
and 2 to switch the BM1 on or off. You
can use a signal switch to do this. Most
customary signals with double-coil drive
are equipped with a switch like this.
Information BM1