Boundary Wire Basics; Pegging The Boundary Wire; Burying The Boundary Wire; Joining The Boundary Wire - Worx Landroid WG795E Bedienungsanleitung

®
Your Landroid L will cut its best in dry weather. It does not like wet grass, which can build up on the Blade Turning Disc (16)
and within the motor, and can also cause loose traction and slippage while working.
®
Your Landroid L is afraid of Lightening Storms. In case of a Lightening Storm, protect the Landroid
Charging Base (3), disconnecting the Boundary Wire (23), and making sure the Landroid
®
Your Landroid L loves mowing grass and needs its Cutting Blades (17) kept in good condition to cut its best. The Landroid
can do most things by itself, but will need your help sometimes to keep from hurting itself.
• Never let the Landroid
• Remove or block off obstacles that the Landroid
• Remove all debris and foreign objects from your lawn.
4.

Boundary Wire Basics

4.1 Pegging the Boundary Wire

Use the Boundary Wire Distance Gauge (26) to set the correct
distance from the border of your lawn (approx. 45cm *).
* This is the recommended distance. Use the provided distance
gauge to ensure proper installation.
If your neighbor also uses a Landroid
spacing of at least 3 metres between your Boundary Wire and your
neighbors.
Please be aware that your Landroid
signal from the Boundary Wire beyond the distance of 25m.
The boundary wire must outline the intended mowing area exactly.
®
Your Landroid L will become confused by extra bends or coils of
Boundary Wire that are not part of its mowing area ( See Fig. H).
If there is excess Boundary Wire after the mowing area has been
outlined, then cut it off and store this additional wire in a separate
location. However, it is important to leave the necessary length where
it connects to the Charging Base so it can be connected and still
12
remain buried.

4.2 Burying the Boundary Wire

We recommend that you bury your boundary wire a few centimeters
underground. This will ensure trouble-free operation year after
year, season after season. For burying the Boundary Wire you may
purchase the optional WORX Territorial Marker Tool accessory at the
same store that sold you your Landroid
If you are planning to bury the Boundary Wire then it should be noted that when entering its Charging Base for the first
time, your Landroid
Boundary Wire to the lawn so it is easy to make adjustments if necessary. This will allow the Landroid
adjusted to its new environment and ensures it will successfully work with the charging base before the Boundary Wire is
buried.

4.3 Joining the Boundary Wire

IMPORTANT: The Boundary Wire will not work properly if it is joined to extend over a distance of 250m.
The Boundary Wire (23) can be extended simply by splicing the ends and connecting it to the ends of another piece of wire.
You can use scotch tape to secure the joined part of the wire. (See Fig. I)

4.4 Turn on and Test Installation

®
If your Landroid
the boundary wire ends incorrectly. Just reverse them.
Lawn Mowing Robot
®
L travel over gravel.
®
L, then you must keep a
®
L will not be able to receive a
®
L.
®
L may find problems with the way you have laid the wire. It is recommended to first peg down the
L is inside its territory but the display says "out of cutting area" and the LED is on, it means you clamped
®
L could accidentally climb and hurt its Blade Disc on.
H
I
®
L by unplugging the
®
L is not allowed to charge.
®
L to become
®
L
EN