HENGST FILTRATION Blue.care+ Originalbetriebsanleitung Seite 21

7. Pull on the handle until the filter can be removed, and place it directly in the plastic bag. Avoid bum-
ping the filter. Close and seal the bag.
GB
Handle
8. Install the new filter in the correct position (note the marking on the filter). The handle points to
the maintenance flap, with the plastic side facing down (black) and the arrows on the filter pointing
upward in the direction of flow.
9. Push the filter all the way in.
Note:
Do not touch the filter in the area of the folds, since they can easily be damaged, which
would impair the function of the filter.
38. | Original operating manual | Article number 129-300-000 I Subject to alteration
10. Use a size 17 wrench to lock the two locks on the left and right of the clamping mechanism, evenly
tightening until snug. Check that the filter is clamped firmly and the seal of the filter frame is in con-
tact with the top of the housing to create a good seal.
Filter seal in contact with
machine housing
Filter clamp
11. Close the machine doors. Then lock the maintenance flap by turning the two locks a quarter turn with
the included key.
Maintenance
flap locks
12. The HEPA H14 filter consists of materials that can be disposed of with the household waste. In ad-
dition, please observe the applicable statutory requirements and local regulations.
| Original operating manual | Article number 129-300-000 I Subject to alteration
GB
39.