TEC B-480-QP Serie Bedienungsanleitung Seite 17

5. LOADING THE MEDIA
10. The media is now loaded and the sensor position is set.
Batch type:
NOTE: Set the selection switch to the STANDARD/STRIP position. Improper setting can affect the print
quality.
Strip type:
1 Remove enough labels from the leading edge media to leave 500 mm of backing paper
exposed.
2 Wind the backing paper onto the take-up spool and fix in position with the take-up clip.
(Wind the paper counter clockwise around the spool as this is the direction it rotates.)
3 Rotate the take-up spool anti-clockwise a few times to take up any slack in the backing paper.
Front Plate
Black Screw
(HAA-0004001)
NOTES: 1. The backing paper is easier to feed back to the take-up spool if the front plate is removed.
2. When fitting the tace-up clip the longer side of the clip should be fitted into the shallow groove
on the take-up spool.
3. Set the selection switch to the STANDARD/STRIP position.
Media
Media
E5-5
ENGLISH VERSION EO1-33007
5. LOADING THE MEDIA
Fig. 5-9
Take-up Spool
Take-up Clip
Backing Paper
Fig. 5-10