Behringer POWERPLAY P1 Schnellstartanleitung Seite 25

Controls
(EN)
(1) PHONES output accepts an 1/8" (3.5 mm)
TRS headphone plug.
(2) BATTERY STATUS LEDs display the current
battery life. When a new battery is
installed, and the power is turned on,
the green LED will light. As battery life
decreases, both LEDs will light, indicating
that the voltage is between 6.8 and 7.3 V.
When only the red LED is lit, the battery
should be replaced.
(3) VOLUME knob adjusts the overall output to
the headphones.
(4) BALANCE knob adjusts either the panning
of a stereo source connected to both
inputs, or the balance between mono
sources connected to inputs L/1 and R/2.
(5) MODE button determines if the audio
connected to inputs 1 and 2 are mixed
in stereo or dual mono. In STEREO mode,
the audio connected to INPUT (L) is routed
to the left side of the headphones and the
audio connected to INPUT (R) is routed to
the right side of the headphones. In MONO
mode, the audio connected to INPUTS
(L) and (R) are routed to both sides of
the headphones, and the volume level
between the two sources is adjusted with
the BALANCE knob.
Quick Start Guide
(6) ON/OFF button turns the power on and off.
(7) DC IN accepts a 9 V power adapter.
(8) INPUT (L) accepts signals via XLR cables,
which are either routed to the left
channel in stereo mode, or to channel 1 in
mono mode.
(9) INPUT (R) accepts signals via XLR cables,
which are either routed to the right
channel in stereo mode, or to channel 2 in
mono mode.
25