Zeroing The Elevation Dial For K1050 / K1050I Ft; Zeroing The Windage Dial For K1050 / K1050I Ft - KAHLES K16i Bedienungsanleitung

9. You have now deactivated the zero stop feature. Your rifle
scope will now have full elevation travel.
NOTE: The mechanical (physical) stop will be about 3 or 4
clicks below zero. This allows adjustments slightly below zero
for special conditions as increased temperature or closer
targets.
Pay attention, never use any strong force when you do any adjust-
ments on the turrets.

6.3 Zeroing the elevation dial for K1050 / K1050i FT

Using the supplied allen key loosen the two set screws on
the turret 1– 3 turns (do not remove the set screws com-
pletely) until you have a free moving turret without any
clicks. With the set screws
loosened turn the elevation
turret in the down direction
(the direction of bullet impact
is engraved on the adjustment)
so that the zero on the dial
lines up with the indicator
mark on the body tube. Align
the marks and use the short
end of the supplied allen key to tighten the two set screws to
approximately 1 Nm or 8 inch pounds (do not exceed 1 Nm or
8 inch pounds). Your elevation is now zeroed.
Pay attention, never use any strong force when you do any adjust-
ments on the turrets.
6.3 a Zeroing the windage dial for K1050 / K1050i FT
With the rifle and scope sighted in to the
desired point of impact loosen the two
set screws on the windage adjust ment
dial 1– 3 turns (do not remove the set
screws completely) and move the dial to
align the zero mark to the indicator mark
on the body tube. Using the short end of
the supplied allen key, tighten the two
Never miss THE MOMENT!
K AHLES –
E
Symbol picture
Symbol picture
23