Other Functions - Ayce DC-057 Gebrauchsanweisung

Operation
1. Plug the power cord into a rated electrical outlet, turn on the main power switch (on
the back of the humidifier). Then display lights up.
2. Start up setting: Press the button
after 1 to 12 hours.
To cancel the setting, press the key
position.
3. Press button to activate the device.
4. Timing on: Once display lights up, press button
between 1 and 12 hours later to work. Each press this key, it can add 1 hour.
( 0,1,2,3,4,......12,0,1,2,3,4...). After appointment, display window will be show
appointment time, it means appointment is finished.
5. Setting the humidification volume: The device has 3 different humidification
stages. (P1,P2,P3). The setting is made by pressing the button once or several
times on the control panel. Press «+» or «-» on the remote control to set the
humidification volume. The default is Level 3.
6. When the appliance is running, press button
accordance with the procedures set humidity to run. On this sleep mode, the light
will be dim, if you want to change the mode, you need to press
can change to other mode.
7. If the water is shortage, the icon will be twinkle, and you can hear the sound of
deeps. On the mode of sleep, it will be on mute.
8. Press button again, the appliance can be stopped, and turn off the power
switch, then unplug the power cord from the power outlet.
CLEANING YOUR ULTRASONIC HUMIDIFIER
• Before cleaning, switch off the power supply and disconnect the plug.
• Do not perform cleaning while the machine is running.
Transducer
• The quality of the water can be hard in some places, which favors the formation of
calcareous deposits on the surface of the transducer. Users should then clean the
transducer with a cleaning product.
• Add a little cleaner on the surface of the transducer (depends on the amount of
one or more times to set the starting time
, set the main power switch to the OFF
, it can be appointment
, the appliance will be in
again, then you
calcium deposits), then infuse water into the mouth to impregnate it completely for
2 - 5 min.
• Clean with a cloth until the calcareous deposits disappear.
• Rinse twice with water.
• Do not clean the transducer with hard or metallic material, do not scrape to prevent
damage.
Interior of the filling mouth
• Remove the water from the mouth, clean the lime deposits, then wipe with a damp
cloth.
• Rinse with water.
• Do not pour water directly into the mouth when cleaning its interior.
Interior of the water tank
• Clean the mouth and the water tank at least twice a week if the machine is used
frequently.
• Use a soft cloth to wipe it in case of scale deposits on the inside of the water tank.
• Do not use corrosive, alkaline or acidic cleaning agents in the water tank to prevent
damage.
Water filter
• Replace the water filter every 8 to 10 weeks to extend the life of the dehumidifier.

OTHER FUNCTIONS

In cold weather, windows, and even some walls, may become damp or frosty in the
event of excessive indoor humidity. If this happens, reduce the mist intensity setting to
avoid any water condensation damage to window sills. Excessive moisture in a room
can cause moisture to accumulate on surfaces, where bacteria and fungi can grow.
Moisture buildup can also damage furniture and walls, especially wallpapers. To
remove excess moisture, especially in a small room, leave the door open and adjust the
fog intensity.
42 | 43 G