Packaging The Food - Simfer CS1150 Bedienungsanleitung

power network warning light and red coloured temperature warning on
the control panel light will be lit.
2. Set the thermostat knob to any position you wish.
3. When the light goes off you can load your foods to the freezer.
4. The red warning light will again be lit when the upper lid of your
freezer is kept open for a long time or when you add new bunch of
foods inside.
5. Set the knob to quick freezing position and switch the freezer on at
least 24 hours before loading the fresh foods. Do not open the upper
lid for 24 hours.
Attention! Do not open the upper lid not to cause heat loss in case
of any long-term power interruptions.

PACKAGING THE FOOD

1. Place the foods in the package.
2. Evacuate the air inside by pressing down.
3. Shut the package tightly.
4. Check if there is any leakage around the package.
5. Write the content and date information down the package.
Remember to operate your chest freezer at least for twenty four (24)
hours unloaded and on quick freezing position before loading the foods.
Switch the thermostat arrow to SUPER position on A++ products and
to MAX position on A+ products. Make the loading after 24 hours.
Your A++ refrigerator will return to its normal operation period after
a certain while. And on A+ refrigerator, switch the thermostat arrow
to FREEZER position after 24 hours. In this way your refrigerator will
return to its normal operation period. Pack your foods up in a way
that no leakage will emerge before placing inside your chest freezer.
Otherwise the foods will lose their taste and become dry. Pack your
foods with suitable packing materials such as aluminium foil, locker
bag, plastic container and etc.
Pack the foods by separating them in portions according to your daily
or meal-based needs.
21