Westinghouse WKCM504 Bedienungsanweisungen Seite 6

FILLING BY REMOVING THE WATER TANK
1. Hold the water grip at tilting angle as shown in direction to remove the water
tank from the machine.
2. Fill the tank up to the "MAX" mark with fresh water (max. 35°C).
3. Slide the water tank slowly on water tank base, when the water tank outlet
is inserted in the inlet receptacle, pushing firmly on the water grip as shown in
direction 2 to lock the water tank.
NOTE:
• Add at least 20 mL of water.
• Water level must not exceed the maximum mark (max.)!
• Use distilled water only. Never use hot water, non-filtered tap water or other
liquid.
• The maximum temperature of the water is 35°C.
• The maximum capacity is 0.7 L.
FLASHING OUT
Before using for the first time or not using for a long time, the machine must be
flushed out. This short procedure can flush out and cleans the internal piping
thoroughly.
1 Fill the water tank to max level.
2. Connect the machine to an electric socket and turn on the AC mains, the (on/
off) button lights up. About 45 seconds later, all 3 buttons will light up,
meaning the machine is ready to use.
3. Press the small cup / big cup button, wait for the appliance to complete the
flush out.
NOTE: Before pressing the button, make sure that:
- the lever is closed without capsule inside.
- the water tank is full.
- the water tank is firmly in place.
- a large bowl ( 250 mL size or above) is placed under the dispenser.
EN
6
Untitled-1 6 22/8/2019 18:24:12