Fujitsu KVM series2-1602 Schnellinstallationsanleitung

The following instructions will allow you to set
up your KVM series2 system easily.
Should you require assistance, please consult your
installer/user guide.
Optimal screen resolution
For an optimal screen resolution of 1280x1024, limit the
cable length between the switch and the attached servers
to 15 meters. Cable lengths greater than 15 meters will
limit screen resolution.
About the KVM series2-Adapter module
The KVM series2-Adapter module is one part of the KVM
series2-1602 / 0801 system and is designed to drastically
reduce cable bulk. Choose between PS/2, USB and Sun
cable options. Use your KVM series2-Adapter module to
convert keyboard, monitor and mouse signals from a server
through a single CAT 5 cable (up to 98.5 feet or 30 meters) to
your unit.
The KVM series2-Adapter module draws its power from the
server and has Keep Alive functionality that will keep your
server working properly with or without connectivity to the
KVM series2-1602 / 0801 unit.
Fujitsu Technology Solutions GmbH, User Documentation, 33094 Paderborn, Germany • Email - manuals@ts.fujitsu.com • Online - http://ts.fujitsu.com/support
All hardware and software names used are trademarks of their respective manufacturers.
Quick Installation Guide
KVM series2-Adapter
KVM series2-Adapter
module - Sun
KVM series2-Adapter
module - USB
Troubleshooting tip
Make sure your server is powered up before operating your
KVM series2-1602 / 0801 system. If a server is unavailable
through OSCAR, double-check your cable connections or test
another KVM series2-Adapter module in its place.
1
Connecting the KVM series2-Adapter to your unit
Choose an available port, labeled 1-16 (or 1-8 on the 0801
unit), on the rear of your unit. Plug one end of a CAT 5
cable into a numbered port and the other end into the RJ45
connector of a KVM series2-Adapter module.
2
Connecting a server to the KVM series2-Adapter
Plug the KVM series2-Adapter module's VGA monitor,
keyboard and mouse connectors into the appropriate port
KVM series2-1602 Appliance (shown)
KVM series2-Adapter
module - PS/2
on the back of a server. Repeat this procedure for all servers
that are to be connected to the KVM series2-1602 / 0801 unit.
NOTE
: For use with Listed Information Technology
Equipment (I.T.E.).
3
Powering up your system
Power up your servers and KVM series2-1602 / 0801unit.
Ensure that your unit is properly confi gured, then begin
operation.
For additional information
For further information, please refer to the KVM series2-1602 /
0801 Installer/User Guide included with the unit. For the latest
software and fi rmware updates, check www.fujitsu.com.
CAT 5 cable - up to 98.5
feet (30 meters)
590-336-609J