Werbung
Verfügbare Sprachen
Verfügbare Sprachen
PAK-308M /SW
Order No. 25.5110
PA Speaker System
GB
with 370 W Amplifier
Please read these operating instructions care-
fully prior to operating the unit and keep them for
later use.
1 Applications
The speaker system PAK-308M / SW is suited for
numerous PA applications and can be used in
fixed installations and for mobile applications. It
is possible to use the speaker system as a floor
monitor or to fasten it to a wall by means of the
mounting bracket or to place it on a speaker
stand using the stand sleeve.
The speaker box is designed as an 8 / 2 full-
range bass reflex system and is equipped with
a 20 cm bass speaker (8") and a coaxial
25 mm tweeter (1"). A digital amplifier (class D,
300 W
) is used for bass frequencies, and an
RMS
analog amplifier (class A / B, 70 W
for high frequencies. The audio signals pass a
digital signal processor (DSP) including a signal
limiter.
2 Safety Notes
The unit corresponds to all relevant directives of
the EU and is therefore marked with
WARNING The unit is supplied with haz-
ardous mains voltage. Leave ser -
vicing to skilled personnel only!
Inexpert handling may result in
electric shock.
G
The unit is suitable for indoor use only. Protect
it against dripping water and splash water,
high air humidity and heat (admissible ambi-
ent temperature range: 0 – 40 °C).
G
Do not place any vessel with liquid on the unit,
e. g. a drinking glass.
G
Do not operate the unit and immediately dis-
connect the mains plug from the socket
1. if the unit or the mains cable is visibly dam-
aged,
2. if a defect might have occurred after the unit
was dropped or suffered a similar accident,
3. if malfunctions occur.
In any case the unit must be repaired by
skilled personnel.
G
Never pull the mains cable to disconnect the
mains plug from the socket, always seize the
plug.
G
For cleaning only use a dry, soft cloth; never
use water or chemicals.
G
No guarantee claims for the unit and no liabil-
ity for any resulting personal damage or mate-
rial damage will be accepted if the unit is used
for other purposes than originally intended, if it
is not correctly connected or operated, or if it
is not repaired in an expert way.
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harm-
ful to the environment.
) is used
RMS
3 Connections and Control Elements
Prior to connecting or changing connections,
.
always switch off the speaker system and the
units to be connected!
1 Input signal switch to switch between micro-
phone level and line level for input A
2 Switch for sound adjustment
MUSIC
= music reproduction
FLAT
= no sound modification
LOWCUT = filter for suppressing low fre-
quencies (≤ 120 Hz) activated
3 LED indicators
ON = power indicator
SIG = signal indicator
CLIP = overload indicator
4 Volume control MASTER
CAUTION Never adjust a very high vol-
accustomed to high volumes which do not
seem to be that high any more after some
time. Therefore, do not further increase a
high volume after getting used to it.
5 POWER switch
6 Inputs (XLR / 6.3 mm jack, bal.) to connect
units with line outputs (mixer, MP3 / CD player,
etc.)
When the input signal switch (1) has been
set to the position MIC, a microphone can be
connected to the upper jack A.
7 Feed-through outputs
At these outputs, the signals of the corre-
sponding input jack (6) are available so that
they can be sent to another active speaker
system, for example.
8 Output jack MIX OUT
At this jack, the mixed signal of the two input
jacks (6) is available; the level depends on
the position of the control MASTER (4).
9 Support for the mains fuse
Always replace a blown fuse by one of the
same type.
10 Mains jack for connection to a mains socket
(230 V~ / 50 Hz) by means of the mains cable
supplied
®
MONACOR INTERNATIONAL GmbH & Co. KG • Zum Falsch 36 • 28307 Bremen • Germany
©
Copyright
by MONACOR INTERNATIONAL. All rights reserved.
ume. Permanent high vol-
umes may damage your hear-
ing! The human ear will get
4 Specifications
Amplifier power
bass: . . . . . . . . . . . . . 300 W
RMS
treble: . . . . . . . . . . . . 70 W
RMS
Frequency range: . . . . . 60 – 20 000 Hz
Inputs
sensitivity: . . . . . . . . . 775 mV (LINE),
input A can be
switched to
10 mV (MIC)
impedance: . . . . . . . . 20 kΩ
connection: . . . . . . . . combined
XLR/6.3 mm jack,
balanced
SPL (1 W/1 m): . . . . . . . 97 dB
Max. SPL: . . . . . . . . . . . 118 dB
High pass filter (low cut): 120 Hz, 24 dB / octave
Power supply: . . . . . . . . 230 V~ / 50 Hz
Power consumption: . . . 350 VA max.
Ambient temperature: . . 0 – 40° C
Dimensions: . . . . . . . . . 340 × 303 × 379 mm
Weight: . . . . . . . . . . . . . 10.75 kg
Subject to technical modifications.
A-1515.99.01.01.2014
Werbung
