Werbung
Verfügbare Sprachen
Verfügbare Sprachen
IMPORTANT - NOTE!
1. The rated charging voltage of this product is 5V, please charge ti-
mely when power is low, so as to avoid the service life loss caused
by battery over-discharge.
2. The thermal imager is not recommended to use in high-tempera-
ture environment for a long time, if the temperature is too high, the
imager will enter the high-temperature protection state, and auto-
matically shut down.
3. The use of temperature is recommended at -10°C to +50° C.
4. Make sure that the USB/MCX port cover on the bottom of the ther-
mal imager is tightly plugged firstly when using in water environment,
such as rainy days.
5. Under any circumstances (whether on or off), do not expose the
thermal imager directly into the high-intensity radiation sources (such
as the sun, laser, etc.), to avoid irreversible damage to the device.
6. The B correction mode will reduce the frequency of automatic
shutter correction after the condition of the device become stable. If
the image gets worse, please cover the lens cover for manual back-
ground correction.
7. When the device is not used for a long time, it should be charged
at least 2 months during storage and stored in a dry and ventilated
environment.
8. Do not shine the laser pointer on human eyes.
9.The laser and cursor function depends on the legal restrictions of
different countries and region.
10. Do not be charged in an environment above 40° C.
Berger & Schröter GmbH - Voerder Str. 83 - 58135 Hagen
16
Werbung
