Installation; Right Place For Installation - Beko RDSE465K20W Bedienungsanleitung

3

Installation

3.1. Right place for installation

Call the Authorized Service Provider for installation
of the product. To make the product ready for use,
be careful that the electrical wiring and plumbing
are appropriate by referring to the information in
the user manual. If not, call a qualified electrician
and plumber and have the necessary arrangements
made.
B
WARNING:
for damages caused by operations by
unauthorized persons.
B
WARNING:
power plug of the product should not be
plugged in. Otherwise, there is a danger of
death or serious injury!
WARNING:
A
to where the product will be placed is
so narrow that the product cannot pass
through, pass the product by turning it to
side; otherwise, call an authorized service.
surface.
sources such as cooker, radiators, stove and at
least 5 cm away from electrical oven.
do not store it in humid place.
function efficiently. If the product will be placed
in an alcove, remember to leave at least 5 cm
clearance between the product and the ceiling,
rear wall and the side walls.
remember to leave at least 5 cm clearance
between the product and the ceiling, rear wall and
the side walls. Check if the rear wall clearance
protection component is present at its location (if
provided with the product). If the component is
not available, or if it is lost or fallen, position the
product so that at least 5 cm clearance shall be
left between the rear surface of the product and
the wall of the room. The clearance at the rear is
important for efficient operation of the product.
drops below 10 °C.
Refrigerator / User Manual
The manufacturer is not liable
During the installation, the
: If the doorway of the room
Attach 2 plastic wedges as illustrated below.
Plastic wedges are intended to keep the
distance which will ensure the air circulation
between your refrigerator and the wall. (The
picture is drawn up as a representation and it
is not identical with your product.)
Condenser of your refrigerator is on the rear
side. In order to increase the energy efficiency
by minimizing the power consumption, the
upper part of the condenser on the rear side
of the product must be pulled backwards
and locked as shown in the figure. When the
condenser is pulled back, the right and left
upper holders are locked and the position of
the condenser is fixed.
9/22 EN