Werbung
75189a.fm5 Page 6 Tuesday, February 6, 2001 3:56 PM
DDE 5860
DDL 5890
1. Control panel.
2. Grease filters.
3. Grease filter handles.
4. Bottom halogen bulbs.
5. Telescopic flue.
6. Top halogen bulbs
(selected models only).
Cleaning the grease filter - Fig. 1
Wash the grease filter at least once a month, or
whenever the grease filter saturation indicator flashes
(Extraction speed indicator 2).
1. Unplug the appliance or disconnect the mains
power supply.
2. Remove the grease filters: push the handles back
(a), and then downwards (b).
3. After cleaning the grease filter refit in reverse order,
making sure the entire extraction surface is
covered.
Resetting the grease filter saturation indicator:
Press the extractor OFF button for three seconds. The
grease filter saturation indicator will stop flashing.
Replacing bulbs
1. Unplug the appliance or disconnect the mains power
supply.
2. For the top lamp
(Fig. 2 - selected models only).....
Use a small screwdriver or any other suitable tool to
prise off the lamp cover.
......or for the bottom lamp (Fig. 3)
Open the lamp cover by pressing where indicated at
(c), then rotate the lamp cover outwards.
3. Remove the burnt-out bulb.
Use 20W max halogen bulbs only, making sure not
to touch them with your hand.
4. Replace the lamp cover so that it clicks into position.
Carbon filter Fitting and Maintenance
Fitting the carbon filter - Fig. 4:
1. Unplug the appliance or disconnect the mains power
supply.
2. Remove the grease filters (a,b).
3. Remove the screw and then the filter holder (f).
4. Fit the carbon filter (g) in the filter holder (d).
5. First place the filter holder on the back tongue (e),
then fix it to the hood with the screw provided (f).
6. Refit the grease filters.
Carbon filter maintenance:
Unlike traditional carbon filters, this carbon filter can be
washed and reactivated.
With normal hood use, the filter should be cleaned once
a month. The filter is best washed in a dishwasher at the
highest temperature possible, using a normal
dishwasher detergent. To avoid particles of food or dirt
settling on the filter during washing and giving rise to
unpleasant smells, it is advisable to wash the filter on its
own. After washing, dry the filter in the oven at 100° C for
10 minutes to reactivate it.
The filter will retain its odour-absorbing capacity for three
years, after which it will have to be replaced.
5019 100 75189/A
PRODUCT SHEET
THE CONTROL PANEL
1. Speed decrease button - 5
2. Extraction OFF button.
3. Extraction ON speed increase button - 0
4. Extraction speed indicator 1.
5. Extraction speed indicator 2 and grease filter
saturation indicator (when flashing).
6. Extraction speed indicator 3.
7. Extraction speed indicator 4.
8. Extraction speed indicator 5.
9. Intensive extraction speed indicator.
10. Timed intensive speed button.
The hood operates at this speed for 5 minutes and
then returns to the previous settings. This function
can be cancelled by pressing button 1, 2 or 3.
11. Light ON-OFF switch. Press quickly to switch on the
bottom lights only, press and hold for more than 2
seconds to switch on and off the top lamp, which
may be switched on independently of the bottom
lamps.
Fig. 1
Fig. 3
D
GB
F
NL
E
1.
Fig. 2
Fig. 4
P
I
GR
5.
Werbung
