For Your Safety; Tool Specifications; Noise/Vibration Information; Operating Controls - Würth Master EB 13-2 Originalbetriebsanleitung

EB 20.book Seite 7 Montag, 16. Februar 2009 2:17 14
GB
Sheet Metal Shears
Order number
Rated input
Output
Stroke rate
Maximum workpiece
thickness:
Iron sheet metal
(400 N/mm
Stainless steel sheet
metal
(600 N/mm
Stainless steel sheet
metal
(800 N/mm
Non-ferrous sheet
metal
(250 N/mm
Cutting radius
Weight
Protection rating
Downloaded from www.Manualslib.com
Working safely with this machine is pos-
sible only when the operating and safety
information are read completely and the
instructions contained therein are strictly
followed. In addition, the general safety
notes in the enclosed booklet must be ob-
served. Before using for the first time,
ask for a practical demonstration.
The unit must not be damp and must not
be used in a wet environment.
Before each use of the machine, check
the machine, cable and plug. Have re-
pairs carried out only through the Würth
Master-Service or by a qualified techni-
cian. Insert the plug into the socket only
when the machine is switched off.
Always wear protective goggles, protec-
tive gloves and heavy-duty shoes when
working.
For long hair, wear hair protection. Work
only with closely fitting clothes.
For further notes on safety refer to the enclosed sheet

Tool Specifications

EB 13-2 EB 20-2
0702 713 0 0702 714 0
300 W 500 W
180 W 300 W
3900 min -1 2200 min
2 ) 1.3 mm 2.0 mm
2 ) 1.0 mm 1.5 mm
2
) 1.0 mm 1.3 mm
2
) 2.0 mm 3.0 mm
145 mm
(1.3 mm
sheet) 215 mm
1.6 kg 1.8 kg
/ II
manuals search engine

For Your Safety

Do not carry the machine by the cable.
Always remove the plug from the power supply
socket before carrying out any work on the ma-
chine, when interrupting work and when not using
the machine.
Always place the cable to the rear away from the
machine.
Apply the machine to the sheet metal only when
switched on.
Always provide for secure footing when working.
Firmly clamp the workpiece if it does not remain
stationary from its own weight.
The knife should not rub on the jaws: Possible
danger of cutting tool breakage.
Do not exceed the maximum allowable material
thickness especially when cutting over doublers,
folded joints or welded seams.
Use only original Würth parts and accessories.

Noise/Vibration Information

Measured values
EN 50144.
Typically the A-weighted sound pressure level of the
product is 83 dB (A). The noise level when working
can exceed 83 dB (A). Wear hearing protection!
-1
The typical hand-arm vibration is below 2.5 m/s

Operating Controls

1 Clamping screw
2 Drilling for parallel guide
3 Set screw
4 Fillister head screw
5 Knife
6 Jaws
7 Washer
8 Knife pin
9 Circlip ring
10 Spring plate
11 Clamping surface
12 On-Off switch
Not all of the accessories illustrated or described are included
as standard delivery.
/ II
.
determined according to
2
.
7