Troubleshooting - Manupro MPASP4IN1 Handbuch

erly disposing of this product, you are
also contributing to the effective use of
natural resources. You can obtain infor-
mation on collection points for waste
equipment from your municipal adminis-
tration, public waste disposal authority,
an authorised body for the disposal of
waste electrical and electronic equipment
or your waste disposal company.

13. Troubleshooting

The following table shows fault symptoms and describes remedial measures in the event
of your machine failing to work properly. If you cannot localise and rectify the problem with
this, please contact your service workshop.
Fault
Motor does not run
Reduced vacuuming
power
Possible cause
Check whether the plug is
plugged in.
Check whether there is power
to the socket.
Check whether the vacuum
cleaner on/off switch is
switched on.
Is the brush blocked?
Is the dust bag full of dust?
Is the filter full of dust?
Remedy
Plug the mains plug back in
to the socket.
Call an electrician.
Switch the on/off switch on.
Switch the vacuum
cleaner off to remove the
blockages.
Remove and empty the
dust bag.
Remove and empty the
filter.
GB | 25