Maintenance And Cleaning; Storage; Electrical Connection - Manupro MPASP4IN1 Handbuch

9. Maintenance and cleaning

m WARNING!
Prior to any adjustment, maintenance or
service work disconnect the mains power
plug!
Cleaning
It is recommended to clean the device af-
ter each use. Do not spray the device with
water or clean it under running water. This
can result in electric shocks and can dam-
age the device.
Residual liquid remains in the stainless steel
container (8). To remove residual liquid, take
off the machine head (2) by releasing the
locking hooks (4) from the stainless steel
container (8). Pour out the liquid residue.
Clean the container with a damp cloth.
• Replace paper filter bag when full
• Always keep the device clean. Do not
use cleaning agents or solvents.
• Keep the ventilation slots clean and free
of dirt and dust.
• Clean the device only with a soft brush
or a damp cloth.
• Clean the foam filter (16) with a little
soap and running water and then leave
it to air dry.
Maintenance
The device is maintenance-free.
Service information
Please note that the following parts of
this product are subject to normal or nat-
ural wear and that the following parts are
therefore also required for use as con-
sumables.
Wear parts*:
* Not necessarily included in the scope of
delivery!
• Foam filter
• Paper filter bag
• HEPA filter

10. Storage

Store the device and its accessories in a
dark, dry and frost-proof place that is in-
accessible to children. The optimum stor-
age temperature is between 5 and 30˚C.
Store the electrical tool in its original
packaging.
Cover the electrical tool in order to pro-
tect it from dust and moisture.
Store the operating manual with the elec-
trical tool.
• Wind the mains cable around the top
cable holder (11) at the connection port
for the blower function (12).
• There are four recesses on the top side
of the machine head (2) for storing the
floor nozzle (18), the joint nozzle (19)
and the aluminium tube (22). There are
also recesses on the wheel mounting
base (5) for attaching the metal exten-
sion tube.
• The remaining accessories can be stored
in the stainless steel container (8).

11. Electrical connection

The electrical motor installed is connect-
ed and ready for operation. The connec-
tion complies with the applicable VDE
and DIN provisions.
GB | 23