Samsung HT-F6500 Bedienungsanleitung Seite 18

Connections
2. Plug the power cord of the wireless receiver module into a wall outlet.
3. Turn on the product. The product and wireless receiver module will now communicate with each other and you will
hear sound from the Surround speakers.
* In case of HT-F6530W
Surround
Speaker (L)
Wireless Receiver Module
* This product should be connected with the SWA-6000 only.
* Refer to page 16 for the speakers of HT-F6550W.
| CAUTION |
\
If you want to install the product on the wall, fasten the screws or nails on the wall firmly and use the holes on the
rear of speaker to install. However, when you install it, accessories (nails or screws) and installation is not provided by
the company.
\
Do not let children play with or near the speakers. They could get hurt if a speaker falls.
\
When connecting the speaker wires to the speakers, make sure that the polarity (+/ –) is correct.
\
Keep the subwoofer speaker out of reach of children to prevent children from inserting their hands or alien
substances into the duct (hole) of the subwoofer speaker.
\
Do not hang the subwoofer on the wall using the duct (hole).
\
The wireless receiving antenna is built into the wireless receiver module. Keep it away from water and moisture.
\
For optimal listening performance, make sure that the area around the wireless receiver module location is clear of
any obstructions.
\
If you hear no sound from the wireless surround speakers, switch the mode to Dolby Pro Logic II.
\
In 2-CH mode, you will hear no sound from the wireless surround speakers.
| NOTES |
\
If you place a speaker near your TV set, the screen colour may be distorted because of the magnetic field.
\
Place the wireless receiver module at the rear of the listening position. If the wireless receiver module is too close to
the product, sound from the speakers may be disrupted because of interference.
\
If you use a device such as a microwave oven, wireless LAN Card, Bluetooth equipment or any other device that uses
the 2.4/5.8GHz frequencies near the product, sound from the speakers may be disrupted because of interference.
\
The maximum transmission distance from the product to the wireless receiver module is about 10m, but may vary
depending on your operating environment. If a steel-concrete wall or metallic wall is between the product and the
wireless receiver module, the system may not operate at all, because the radio wave cannot penetrate metal.
\
If the product doesn't make a wireless connection, you need to run an ID Set between the product and wireless
receiver module. With the product turned off, press "0""1""3""5" on the remote control. Turn on the wireless
receiver module. Then, press and hold the "ID SET" button on the back of the wireless receiver module for 5
seconds, and then turn the product on.
18
|
English
Front Speaker (R)
Subwoofer
Surround
Speaker (R)
Front Speaker (L)
SPEAKERS OUT
FRONT
FRONT R L
SUBWOOFER CENTER
Centre Speaker
SPEAKERS OUT
FRONT R FRONT L
SUBWOOFER CENTER
HDMI OUT