Cleaning The Teeth And Guide On The Drill Stand Pillar; Cleaning And Greasing The Eccentric Shaft; Disposal; Scope Of Supply - Baier BST 420 Original Bedienungsanleitung

EN
7.1 Cleaning the teeth and guide on
the drill stand pillar
•
1 Blow the teeth and the guide of the drill stand
pillar (14) with compressed air and rub down
with a cloth to remove the drilling dust.
7.2 Cleaning and greasing the
eccentric shaft
•
9 Use an open-ended spanner to undo the
eccentric shaft (3).
•
9 Pull the eccentric shaft (3) out of the feed
slide (2) up to the limit stop.
•
9 Swing the motor plate (1) upwards and
remove from the feed slide (2) from above.
•
1 Clean and re-grease the thread of the
eccentric shaft (3).
•
1 Re-install the motor plate (1) and the eccen-
tric shaft (3) in the reverse order.
NOTE
Ensure handles are dry and free from grease.
8

Disposal

Recycle the machine and its packaging
in an environmentally friendly way in
accordance with the provisions applicable
in your country.
| 24 |
9

Scope of Supply

Please refer to the enclosed delivery note for the
individual scope of supply of a customer-specific
order.
Please refer to the following list for the scope of
supply of the basic models.
Scope of supply:
•
Drill stand BST 420
•
Instruction Manual
Please contact your dealer if parts are missing or
damaged.
Drill stand
BST 420
ID. No.
7444