Baier BST 420 Original Bedienungsanleitung Seite 16

EN
Imprint
Version V01 / 2020-07
Copyright:
Maschinenfabrik
OTTO BAIER GmbH
Heckenwiesen 26
71679 Asperg
Germany
It is prohibited to forward or reproduce this docu-
ment or to exploit and disclose its contents, unless
expressly permitted. Any infringements will result in
liability to pay compensation for damages. All rights
reserved in case of patent, utility model or design
registration.
This instruction manual has been prepared with
the greatest possible care. Nonetheless, OTTO
BAIER GmbH does not accept any liability
whatsoever for possible errors in this instruction
manual and their consequences. Equally, no liability
whatsoever is accepted for direct or consequential
damage or losses resulting from improper use of the
machine.
The national health and safety regulations and the
requirements of this instruction manual are to be
observed when using the machine.
All product names and brand names used are the
property of the holder and are not explicitly marked
as such.
Subject to change without notice.
| 16 |
Contents
1 About this instruction manual ........... 17
1.1 Important information ............................. 17
1.2 Symbols used in the instruction manual 17
2 Safety Instructions .............................. 17
2.1 Operating personnel requirements ........ 17
2.2 Workplace safety .................................... 18
2.3 Electrical safety ...................................... 18
2.4 Safety of people ...................................... 18
2.5 Using and handling the drill stand .......... 18
2.5.1 Service / Maintenance / Repair .............. 20
2.5.2 Explanation of the pictograms on the
drill stand ................................................ 20
3 Technical Characteristics ................... 21
3.1 Technical specifications ......................... 21
3.2 EU Declaration of Conformity ................ 21
3.3 Controls .................................................. 21
3.4 Intended use ........................................... 21
4 Before Starting Work ........................... 22
5 Operation and Control ......................... 22
5.1 Fixing the drill stand on the floor ............ 22
5.2 Fixing the drill stand on the wall ............. 22
5.3 Fixing the drill stand with a quick-
action pillar ............................................. 22
5.4 Fixing the drill stand with vacuum kit
(accessory) ............................................. 23
5.5 Adjusting the inclination angle at the
drill stand ................................................ 23
5.6 Fixing the diamond drill / drive unit on
the drill stand .......................................... 23
6 Starting Drilling .................................... 23
7 Cleaning ................................................. 23
7.1 Cleaning the teeth and guide on the
drill stand pillar ....................................... 24
7.2 Cleaning and greasing the eccentric
shaft ........................................................ 24
8 Disposal ................................................. 24
9 Scope of Supply ................................... 24
10 Warranty ................................................ 25