Cleaning Instruction; Troubleshooting - Rothenberger Roscope 1000 Bedienungsanleitung

8. Copy and Paste the images into a folder of your choice on your computer's hard drive.
Figure 37 – Image Window
11.

Cleaning instruction

1. Remove battery from unit
2.
Alcohol wipes, mild detergent and water to remove dirt and grease from the product.
3.
Recommend soft optical cloth for cleaning the LCD window.
4. Recommend cotton cloth for cleaning imager head
5. Allow appropriate drying time before re-inserting the battery and operating.
12.

Troubleshooting

Symptom
Display unit does not turn on
Display turns on, but does
not show image.
Display shows an
unresponsive image
Battery does not hold a
charge
Video cuts off after 10
seconds
26
Possible Reason
Battery is discharged
Verify battery is in the
battery compartment
Faulty electronics
Loose cable connection
Imager head covered by
debris
Image processor
encountered an error
Battery may have discharged
slightly during storage
Run time dependent on LED
usage
Battery may be damaged
Life cycles of battery expired
Factory setting for internal
memory
ENGLISH
Solution
Recharge battery
Place battery in the battery
compartment
Contact Rothenberger Service
Center
Check cable connections.
Clean imager head
Turn OFF unit/turn ON to reset
processor
Remove battery when storing
Recharge battery more often
when extensive use of LEDs
Replace battery
Replace battery
Use SD card for videos longer
than 10 seconds.