Hamilton Beach HBH950 Bedienungsanleitung Seite 3

interference. If this occurs, simply reset the
product and resume normal operation by
following the operation manual. If normal
operation cannot be resumed, place the
product in a different location.
• Do not operate any appliance with
a damaged cord or plug or after the
appliance malfunctions, or is dropped or
damaged in any manner. If the supply cord
of this appliance is damaged, it must be
replaced by the manufacturer or its service
agent or a similar qualified person. Refer
to "Technical Services" for instructions
on examination, repair, or electrical or
mechanical adjustment.
– SAVE THESE IN STRUC TIONS –
This appliance is intended for professional use and should be used by trained and qualified personnel only.
Electrical Shock Hazard
Disconnect power before
cleaning blender base.
Failure to follow these
instructions can result in
death or electrical shock.
Electrical Shock Hazard
Plug into a grounded outlet.
Do not remove ground.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can
result in death, fire, or electrical shock.
Cut Hazard
Always place lid on container when
blending.
Do not put hands, spoons, or other
utensils in container when blending.
Failure to follow these instructions can
result in broken bones, cuts, or other
injuries.
The complete CE declaration of conformity documentation for this appliance is available in the
Technical Support section of our website www.hamiltonbeachcommercial.com.
HBH950 series models, rated 220–240 V~ 50–60 Hz
4.6 A, comply with the following statutory directive
and regulations:
• European Machinery Directive 2006/95/EC
• Low Voltage Directive 2014/35/EU
• EMC Directive 2014/30/EU
Recycling the Product at the End of Its Service Life
The wheeled bin symbol marked on this drink mixer signifies that this appliance should be taken over
by a selective collection system conforming to the Guideline 2012/19/EU (WEEE) so that it can be either
recycled or dismantled in order to reduce any impact to the environment. The user is responsible
for returning the product to the appropriate collection facility, as specified by your local code. For
additional information regarding applicable local laws, please contact the municipal facility and/or local
distributor.
• CAUTION: In order to avoid a hazard due
to inadvertent resetting of the thermal cut-
out, this appliance must not be supplied
through an external switching device, such
as a timer, or connected to a circuit that is
regularly switched on and off by the utility.
• UK ONLY: If fitted with a non-rewirable
U.K. plug, the 13 amp fuse approved by
ASTA to be B.S. 1362 must be used. If you
need a replacement fuse carrier, it must
be replaced with the same colour coded
carrier with the same markings. Fuse
covers and carriers can be obtained from
approved service agents.
Burn Hazard
Always use caution when blending
hot contents.
Failure to follow these instructions can
result in burns.
Sanitizing
Sanitize using 1 tablespoon (15 ml) of household
bleach per 1 gallon (3.8 liter) of clean, cool water
(60°F/16°C), mixed according to the instructions
on the bleach.
1. Fill container with sanitizing solution, replace
lid and filler cap and run on LOW speed for
2 minutes. Empty container.
2. Wipe exterior with soft cloth dampened with
sanitizing solution.
3. Immerse lid and filler cap in sanitizing solution
for 2 minutes.
4. Place empty container on base and run on HIGH
speed for 2 seconds to remove any moisture
from the cutter assembly.
5. When ready to use, rinse with clean water.
• RoHS Directive 2011/65/EU
• WEEE Directive 2012/19/EU
• Materials/articles intended for contact with
foodstuffs Regulation 1935/2004/EC
• Plastic materials intended for contact with
foodstuffs Regulation 10/2011/EC
3