Plantronics HL10 Benutzerhandbuch Seite 4

ATTACHING THE EXTENDER ARM (IF REqUIRED)
The Extender Arm is intended to increase the distance from the HL10
to the earpiece of the handset. The Stabilizers (7) can be shifted to
the left or right to improve the stability of the handset on the HL10.
1. Slide the Extender Arm onto the HL10 (Fig. H).
2. Position the Stabilizers (7) on the outsides of the handset to gently
grip the phone (Fig. I).
3. Read "Adjusting the HL10 for Your Telephone" to determine the
correct HL10 height.
MOUNTING THE HL10 IN A PERMANENT POSITION
Once you have determined the best position for the Handset Height
Switch (5), you can mount the HL10 on your telephone base.
1. Remove the protective covers from the Mounting Strips (2) on the
underside of the HL10 (Fig. J).
If the side of the phone is curved, the protective cover on the
NOTE:
side can be left on to improve the fit.
2. Gently, place the HL10 into the position you have identified.
Test that the lifter works (Fig. K).
3. Once you have located the appropriate position, firmly press down
on the top of the HL10 to attach the lifter to the telephone base
(Fig. L).
NOTE: Use a rolling motion to attach the lifter.
4. Place the handset on the HL10.
10
MAKING AND RECEIVING CALLS
While wearing your headset, press the talk button to activate the
HL10. When you hear a dial tone, use the telephone key pad to dial
the number (Fig. M).
To end the call, press the talk button again. The HL10 will return the
handset to the cradle and disconnect the call.
If your headset does not beep when the phone rings, you may need
to adjust the ringer on your phone.
1. For best results, choose a traditional ring pattern on your phone.
2. Set the telephone ring volume at mid range.
3. If necessary, try different settings of ring pattern and volume until
the headset beeps when the phone rings.
If your headset still does not ring, attach the Ringer Microphone
Plug (10) to your HL10 and place the Ringer Microphone (9) over
the ringer speaker of your phone.
USING THE RINGER MICROPHONE (IF REqUIRED)
If the HL10 microphone is not located above the ringer speaker
on your phone, you must install the optional Ringer Microphone
(Fig. N and Fig. O).
1. Remove the cover from the Ringer Microphone Jack (4) on
the HL10.
2. Connect the Ringer Microphone Plug (10) to the Ringer Microphone
Jack (4).
3. Place the Ringer Microphone (9) over the ringer speaker on
the telephone. You should hear a beep in the headset when you
receive a call.
4. Remove the protective cover from the mounting tape and attach
the Ringer Microphone (9) to the telephone ringer speaker.
11