Installation And Wiring; What Is Included In The Box; Tools And Additional Components; Before You Begin - Clarion OHM888VD Bedienungsanleitung

5. INSTALLATION AND WIRING

Do not attempt to install or service your player yourself. Installation and servicing require
experience in electronic equipment and automotive accessories. If you do not have the
knowledge or experience this installation may be dangerous and could expose you to the
risk of electric shock or other hazards.
Read these instructions and precautions carefully. Improper installation can damage the
monitor and the vehicle.

What is included in the box

In addition to this manual, the box contains:
1 Player
1 IR remote control with battery
1 Audio/video RCA cable
6 ST4.2 x 16/ 10 ST4.2 x 16/ 6 ST4.2 x 16 screws
4 CM 4 x 10/ 8 CM 4 x 8/ 4 CM 4 x 8 screws
1 Metal mounting plate
1 Rubber gasket
1 Warranty card
2 Earphones and 4 AAA batteries (OHM1588VD/OHM1088VD)
1 Earphone and 2 AAA batteries (OHM888VD)
Note:
Use only the contents of this package to install and use the DVD player. Using
accessories not provided with this player may damage the player.

Tools and additional components

You will need a Phillips-head screwdriver when mounting the player in the vehicle.

Before you begin

1. Verify that the vehicle electrical components function, including: power windows,
power door locks, air conditioning, lights, etc.
2. Identify the polarity of the dome light circuit and set the switch on the bottom of the
overhead monitor housing.
3. Test fit the location of the overhead monitor system to ensure it will not interfere with
the operation of the vehicle.
4. If applicable, verify that the monitor, when mounted, will not interfere with the operation
of the sun roof.
5. Carefully mark the location with masking tape.
6. Lower the vehicle's headliner down to see if a roof support beam is available to screw
the mounting bracket to.
If a support beam is not available, use a 3/4-inch piece of plywood cut to the
appropriate size. Attach the plywood to the roof of the vehicle using silicone. Allow for
adequate drying time.
7. Determine the location of any additional audio/video sources.
8. Disconnect the negative battery terminal before making any wiring connections.
OHM888VD / OHM1088VD / OHM1588VD
23