Phottix Strato TTL Benutzerhandbuch Seite 9

Connecting a flash to the Strato TTL
receiver hot shoe
1. Turn off the flash and the Strato T TL
Receiver.
2. Slide the flash into the receiver's hot shoe
mount.
3. Lock the flash with the flash's locking
mechanism.
4. Turn on the flash and the Strato T TL
receiver.
5. Set the flash to TTL mode.
Please Note:
It is not unusual for the flash to discharge
once after turning on the Strato TTL.
Downloaded from www.Manualslib.com manuals search engine
EN
Using the Strato T TL to trigger
flashes
1. Half-press the camera shutter button
while the Strato TTL transmitter is connected
to the camera hot shoe and powered on.
When AF-ILL Function is enabled, and it is
difficult for the camera to achieve focus, the
AF assist light of flashes connected to Strato
TTL receivers on the same channel as the
transmitter will illuminate. The Status LEDs on
the transmitter and receiver will turn green.
2. A full-press of the camera shutter button
will fire flashes connected to Strato TTL
receivers on the same channel as the
transmitter. Status LEDs on the Transmitter
and Receiver will turn red.
INSTRUCTION MANUAL
9