Phottix Strato TTL Benutzerhandbuch Seite 13

Strato TTL receiver.
2. Connect a cable to the receiver's 3.5 mm
Sync Port.
3. Connect the opposite end of the cable to
a flash or studio strobe (A 6.3 mm adapter is
included for studio strobes with larger ports).
4. Turn on the flash/strobe and the Phottix
Strato TTL receiver. Set the flash/strobe to
Manual mode (if applicable).
5. Press the Shutter Button of the camera
connected to the transmitter -- flashes
connected to the receivers on the same
channel will fire.
Please note:
- It is not unusual for the flash to discharge
once after turning on the Phottix Strato TTL.
Downloaded from www.Manualslib.com manuals search engine
EN
- Flashes connect to Strato TTL receivers
by cable will have no TTL, Auto FP or SCS
functions, only simple triggering.
Using the Strato TTL as a wireless
shutter release*
1. Turn off the camera and the Phottix Strato
TTL receiver.
2. Attach the correct Phottix Accessory Cable
for your camera make and model to the 2.5
mm Accessory Port on the Strato TTL receiver
3. Attach the other end of the cable to the
camera's remote port.
4. Turn on the camera and Phottix Strato TTL
receiver. Consult your camera manual for
INSTRUCTION MANUAL
13