Inserting Batteries - Phottix Strato TTL Benutzerhandbuch

5. Using the Strato TTL Transmitter in HSS
mode may cause issues with flash sync when
using Strato and Strato II Multi receivers or
Atlas II Transceivers (in RX mode).

Inserting batteries

1. Press the battery cover in while pushing
it away from the Strato TTL transmitter or
receiver. The battery cover will snap open and
slide away from the device.
2. Remove the battery cover from the Strato
TTL.
3. Insert AA batteries.
4. Replace the battery cover and push back
into the locked position.
Downloaded from www.Manualslib.com manuals search engine
EN
Battery Level Indicator
When the battery voltage is higher than
2.4V, the battery level indicator icon will
display four bars
batteries is depleted the bars displayed in
the battery level indicator icon will disappear
- an approximate indication of how much
power remains in the batteries. Use this as a
rough guide to know when a battery change
is needed. When the batteries are exhausted
the battery level indicator will display an
empty with battery icon
LCD Backlight on the transmitter
Pressing any button on the transmitter
w i l l i l l u m i n a t e t h e LC D B a c k l i g h t fo r
INSTRUCTION MANUAL
. As power in the
.
5