Pairing The Devices - Commidt CIBS PERSONAL LISTENER Bedienungsanleitung

on the Liberto until you see a blue light on the
17
Battery indicator lamp
and at the same time you will hear a signal via the T-Loop or via the
connected headset on the CIBS Neck Loop.
How to switch off the CIBS Neck Loop/Liberto:
• Press and hold in the On/Off button
on the Liberto until you see a red light on the
17
Battery indicator lamp
and at the same time you will hear a signal via the T-Loop or via the
connected headset on the CIBS Neck Loop.

Pairing the devices

The devices in the CIBS Personal Listener must be programmed to
communicate with each other. This is done by connecting them wirelessly
(pairing).
NOTE: It is important that the CIBS Neck Loop and the Liberto are within
a distance of 1 meter during pairing and that both devices are fully
charged.
Both units of the CIBS Personal Listener (CIBS Neck Loop and Liberto)
are ready-paired. If any difficulties arise, such as the pairing is deleted,
you can use the instructions below.
•
•
•
•
•
User manual CIBS Personal Listener (NO_GB_F_D_NL_ES_SE_DK_SU) 1f
Downloaded from www.Manualslib.com
Switch on the CIBS Neck Loop (see page 8 for instructions).
Press and hold in the pairing button
until the Battery indicator lamp
flashes alternately red and blue. At the same time, you should
hear a double tone via the T-Loop or via the headset on the CIBS
Neck Loop.
Press and hold in the On/Off button
Battery indicator lamp on the Liberto
and blue
When the CIBS Neck Loop and Liberto are paired, they will
establish communication with each other. The status lamp
the Liberto will illuminate solid yellow. It will do this every time
it communicates with the CIBS Neck Loop.
If the pairing is unsuccessful, repeat this section.
manuals search engine
on the CIBS Neck Loop/
7
on the CIBS Neck Loop/
2
on the CIBS Neck Loop/
7
on the CIBS Neck Loop
7
17
on the Liberto
14
on the Liberto
14
on the CIBS Neck Loop
5
on the Liberto until the
flashes alternately red
14
NO
EN EN
F
D
NL
ES
SE
DK
SU
on
12
9