Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operating instructions
LED disco ball (light effect ball)
Item no. 1362733
Intended use
The LED disco ball effect sphere is used to generate lighting effects at home, on dance floors, in party
basements etc.
Only power the product by batteries (for correct type see „Technical data").
The product may only be used in enclosed indoor locations. Outdoor use is not allowed. Contact with humi-
dity, drips or water spray e.g., in bathrooms, must be avoided at all times.
Any use other than that described above will lead to damage to the product and will expose you to additional
risks, such as short-circuiting, fire, etc.
No part of the product may be modified or converted.
Always observe the safety instructions and all other information included in these operating instructions.
This product complies with the applicable national and European regulations. All names of companies and
products are the trademarks of the respective owners. All rights reserved.
Package contents
• LED disco ball (light effect ball)
• Operating instructions
Explanation of symbols
This symbol points to specific risks associated with handling, function or operation.
This symbol alerts that the product may only be used indoors.
Safety instructions
Read the entire operating instructions carefully; these instructions contain important
information for proper operation.
Damage due to not following these operating instructions will void the warranty! We do
not assume any liability for any resulting damage!
We do not assume any liability for material and personal damage caused by improper use
or non-compliance with the safety instructions! In such cases, the warranty will be null
and void!
• For safety reasons, any unauthorised conversion and/or modification of the product is not
permitted.
• The product is intended as a decorative light, it is not a toy. Keep it out of the reach of children.
• Never position containers containing liquids, such as glasses, buckets, vases or plants, in the
direct vicinity of the product. Liquids may seep into the casing and thus impair the safety of
the device. There is also a very high risk of fire! In such a case, switch off the device imme-
diately and remove the batteries. Do not use the product after that and take it to a specialist
workshop.
• Do not expose the device to high temperatures, dripping or spray water, strong vibrations or
heavy mechanical stress.
• Do not place naked flames, such as burning candles in the immediate vicinity of the device.
• Do not leave packaging materials unattended. It may become a dangerous plaything for chil-
dren.
• Never use the product without supervision.
• Use the product only in a temperate climate and not in a tropical climate.
• You should also heed to the additional safety instructions in each chapter of this instruction.
• If you have any questions that are not answered in these operating instructions, please con-
tact our technical support centre or consult a professional.
Inserting / replacing batteries
•
Keep batteries out of reach of children.
Do not leave batteries lying around in the open; there is a risk of them being swallowed
by children or domestic animals. If they are swallowed, consult a doctor immediately.
Leaking or damaged batteries can lead to caustic burning of the skin. Therefore, use
Version 10/15
suitable protective gloves.
°
Batteries must not be short-circuited, opened or thrown into a fire. There is a risk of
explosion!
Do not recharge normal, non-rechargeable batteries, risk of explosion! Only recharge
rechargeable batteries that are intended for this purpose; use a suitable battery charger.
Please pay attention to the correct polarity (plus/+ and minus/-) when inserting the bat-
tery.
Remove batteries from the device if you will not be using it for a longer period.
• Open the battery compartment on the bottom of the effect sphere.
• Insert three new 1.5 V Mignon batteries (AA) paying attention to the correct polarity. The correct polarity is
stamped on the bottom of the battery compartment .
• Screw the battery compartment lid back on again.
• If the light intensity decreases or the effect sphere does not function any more, the batteries have to be
replaced.
Positioning
When positioning ensure safe position.
Serious injury to persons can be caused by falling of the device.
• Place the effect sphere on a flat stand surface.
Operation
• Switch the effect sphere on or off by pressing switch on the casing.
Position I
→
Position O →
Maintenance and cleaning
This device is maintenance-free.
Please use a soft, dry, clean cloth for cleaning.
Never use aggressive cleaning agents or chemical solutions as these may damage the surface of the
housing.
Disposal
a) Product
Electronic devices are recyclable waste materials and must not be disposed of in the household
waste!
Please dispose of the product, when it is no longer of use, according to the current statutory
requirements.
Remove the batteries that may be inserted and dispose of them separately from the product.
b) Batteries and rechargeable batteries
As the end user, you are required by law (Battery Regulation) to return used batteries. Do not dispose of
used batteries in the household waste!
Batteries/rechargeable batteries containing hazardous substances are labelled with the symbol
shown to indicate that disposal in household waste is forbidden. The symbols of the critical
heavy metals are: Cd=cadmium, Hg=mercury, Pb=lead (marking can be seen on the battery /
rechargeable battery, e.g., underneath the refuse bin symbol shown on the left).
You can return your used batteries/rechargeable batteries free of charge at the official collection points of
your community, in our stores, or at places where batteries or rechargeable batteries are sold!
You thereby fulfil your statutory obligations and contribute to the protection of the environment.
Technical data
Operating voltage ..........................................4.5 V/DC
Batteries ........................................................ 3x 1.5 V Mignon cell (AA)
Battery life ......................................................approx. 38 h (with alkaline batteries)
Illuminant .......................................................1x LED
Dimensions (Ø x H) .......................................95 x 122 mm
Weight ...........................................................110 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent
the technical status at the time of printing.
© Copyright 2015 by Conrad Electronic SE.
Effect sphere is on
Effect sphere is off
Werbung
