Renkforce CR27E Bedienungsanleitung Seite 2

Operating instructions
USB 3.0 card reader CR27E
Item no. 1371587
Intended use
The product is intended for reading and writing on SD memory cards.
It is intended for indoor use only. Contact with moisture, e.g. in bathrooms, must be
avoided under all circumstances.
For safety and approval purposes (CE), you must not rebuild and/or modify this product.
If you use the product for purposes other than those described above, the product may
be damaged. In addition, improper use can cause hazards such as short circuiting,
fire, electric shock etc. Read the instructions carefully and keep them. Make this
product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All
company names and product names are trademarks of their respective owners.
All rights reserved.
Delivery content
• Card reader
• Operating instructions
Safety instructions
Read the operating instructions carefully and especially observe the safety
information. If you do not follow the safety instructions and information on
proper handling in this manual, we assume no liability for any resulting
personal injury or damage to property. Such cases will invalidate the
warranty/guarantee.
a) Persons / Product
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. These may become
dangerous playing material for children.
• Protect the product from extreme temperatures, direct sunlight, strong jolts, high
humidity, moisture, flammable gases, vapours and solvents.
• If it is no longer possible to operate the product safely, take it out of operation and
protect it from any accidental use. Safe operation can no longer be guaranteed if
the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height
can damage the product.
• Also observe the safety and operating instructions of any other devices which are
connected to the product.
b) Miscellaneous
• Consult an expert when in doubt about operation, safety or connection of the device.
• If you have questions which remain unanswered by these operating instructions,
contact our technical support service or other technical personnel.
Connection
1
4
2
3
Notes
• No drivers are required.
• Status indicator: Constant when in standby mode and flashes when data is being
transferred.
• Pay attention to the information on using peripheral devices in the operating
instructions for the computer/portable devices which you connect to the card
reader.
• For some operating systems for portable devices the capacity of the memory card
is limited (e.g. 32 GB).
• Depending on the operating system, not all memory card types/systems (e.g. NTFS,
exFAT) are supported.
• Never disconnect the card reader or remove a card when data is being transferred.
Data may be lost or become corrupted.
• The memory card must be ejected from the device before removing to prevent data
loss, data corruption or damage to the product. Refer to the instructions for your
operating system.
Maintenance and cleaning
• Do not use any aggressive cleaning agents as these may lead to discoloration. To
prevent scratch marks, do not apply too much force on the surface during cleaning.
• Switch off the product and disconnect any connected devices before cleaning.
• Besides occasional cleaning, the device is maintenance-free. To clean the device,
use a soft, anti-static and lint-free cloth.
• You can use a clean, long-haired brush to easily remove any dust.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the
household waste.
At the end of its service life, dispose of the product according to the
relevant statutory regulations.
You thus fulfil your statutory obligations and contribute to the protection of
the environment.
Technical data
Power supply .......................................5 V/DC (via USB)
Supported memory cards ..................SD, SDXC, SDHC, Micro SD, MMC
System requirements .........................Windows
USB standard.......................................USB 3.0
Operating/storage conditions ...........-30 to +65 °C, ≤85 % RH
Dimensions (W x H x D)......................71 x 13 x 24 mm
Weight ...................................................approx. 17 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication represent the
technical status at the time of printing.
© Copyright 2015 by Conrad Electronic SE.
XP (Home, Pro with SP1, 2, 3, 32 bit)
®
Vista™, 7, 8, 8.1 (32/64 bit), RT
Mac OS 10.2.8, 10.8.3
Linux 17, Linux Kernel 3.5.X
V1_0815_02-HK